answersLogoWhite

0

The speed used would depend on the hardness and thickness of the wood. I generally start off slowly and increase speed till it feels comfortable and does not bend the blade.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Which cutting tool has the highest cutting speed?

How fast lathes, cutting speed can be fast, it has a relationship with the feed amount and diameter.


What is cutting speed in cnc machines?

cutting speed is a combination of depth of cut and feed.


What speed should a wood cutting band saw blade be?

The speed used would depend on the hardness and thickness of the wood. I generally start off slowly


What are the unit of cutting speed and feed on machine tool?

feed mm/sec speed Rev/min RPM for cutting tool


How can I speed up the cutting process on my Silhouette Cameo machine, which seems to be cutting slowly?

To speed up the cutting process on your Silhouette Cameo machine, you can try adjusting the cutting speed settings in the software. Increasing the speed can help the machine cut faster, but be careful not to set it too high as it may affect the cutting quality. Additionally, make sure the blade is sharp and the cutting mat is clean and properly aligned for optimal performance.


How do you measure lathe speed?

lathe speed is numerically measured by cutting speed vdn/1000.


Why can a helicopter reach a terminal speed whilst falling during autorotation?

GAYS


Average cutting speed of stainless steel in lathe machine?

Obviously it would depend on the stainless grade because stainless is an alloy, so the speed rate would differ slightly depending on your grade. The most important factor would be the type of cutter you use, if you are using Carbide cutting tools, with sufficient coolant you can run it at about 90-110 m/p/m (90 to 100 meters per minute) If you using high speed steel cutters run it no more than about 30m/p/m. My best advice to you is to ask for the manufactures recommendations they will give you a limit to work in, always start between lowest and middle of manufactures speed recomendations and then work your way up in speed if necessary. If your speed is correct you get a better finish and longer toolife. Remember that if you run tools at higher speeds you decrease their life, the time taken to cut the material is determined by the feed-rate and not the speed, even on a lathe which has feed set to federate per revolution will only differ slightly. Hope this helps…


What is speedometer pointer?

a speedometer pointer is were there is a pointer were basically it points what speed your in whilst your driving


Why is your Nissan 1400 with a carburetor not idling properly it keeps on cutting?

replace the carburetor idle speed electrovalve. Should pay about $3.00 for a new replacement part.


What is the spindle speed for the carbide cutting tools?

I thought you knew....


What can be made from high speed steel?

drills, cutting tools