Want this question answered?
Open circuit and short circuit tests are performed to determine transformer characteristics. In the case of a single phase transformer, SC tests would be performed to determine the impedance. The open circuit test will give excitation information (% excitation at specific voltages, often 90%, 100% and 110%, and no load losses).
Coombs' tests are blood tests that identify the causes of anemia
By performing no load and short circuit tests. These are outlined in ANSII and IEEE literature.
Firstly turn of the power before this test...Using a resistance or continuity tester you should get the following results:Short circuit: Very low resistance (nearly 0 ohms) or the bell will ring.Open circuit: Very high resistance (Somewhere in the range of Mega ohms) or the bell will not ring.The reason for this is because and open circuit has a gap in it (which has high resistance).The short circuit has wires that are crossed and so has a really low resistance.
There are many different tests that can be used to identify different metals. Using a magnet is a popular test to distinguish metals.
Special immunologic and serologic tests may also be used to help identify the infectious agent.
to identify minerals
The following procedure tests for a short to voltage in a circuit.1. Set the rotary dial of the DMM to the V(DC) position.2. Connect the positive lead of the DMM to 1 end of the circuit to be tested.3. Connect the negative lead of the DMM to a good ground.4. Turn ON the ignition and operate all accessories.5. If the voltage measured is greater than 1 volt there is a short to voltage in the circuit.
Neuropsychological tests can identify syndromes associated with problems in a particular area of the brain.
These two tests are performed on a transformer to determine (i) equivalent circuit of transformer(ii)voltage regulation of transformer(iii) efficiency of transformer. The power required for theseOpen Circuit test and Short Circuit test on transformeris equal to the power loss occurring in the transformer.
Flame tests are used to help identify substances used in murders
These are not specific tests.