An active device is any type of circuit component with the ability to electrically control electron flow (electricity controlling electricity). In order for a circuit to be properly called electronic, it must contain at least one active device
Passive Load is Load comprising of Passive Components Active Load is the Load comprising of Active Components In Test Boards its better to use Active Loads, If you are concerned about Temperature Variations during characterisation
An active antenna is an antenna which has an amplifier attached very closely to it. The antenna/amplifier system is called an active antenna. It is used for receiving signals only. The idea is to set the signal-to-noise ratio (SNR) before the signal travels along a transmission line where it is susceptible to interference and loss.
A passive device is a diode resistor coil and so forth it perform no enhancement to the circuit or act on it.
A capacitor is passive like a resistor is passive it performs no active amplification.
it is not a passive device .y because it is used to amplify the voltage and current .so as according to the definition of active device is the device which is used to amplify the current r voltage .hence transistor is a active device.
passive
An active device amplifies the signal by some value - such as an active filter using an OPAMP. A passive device does not provide any amplification - such as a passive filter network of inductors and capacitors.
diode is a two terminal passive non linear device.
Passive Load is Load comprising of Passive Components Active Load is the Load comprising of Active Components In Test Boards its better to use Active Loads, If you are concerned about Temperature Variations during characterisation
They are both passive devices. An active device is a device that uses semiconductors (or tubes) to process signals instead of using the natural processes of capacitance, inductance or resistance.
A: The difference is PASSIVE / ACTIVE
Yes, it is an electrically operated switch.
An active device is a device that takes input energy to operate. The only energy a diode uses is from the signal applied to it (it has one input, one output, and no other terminals), so it is a passive device. To be an active device, a separate power source must be applied to it - such as the case for operation amplifiers, for example.
Either. although a passive device can only produce gain from 0-1 (-inf to 0dB) an active device on the other hand is capable of producing gain thats greater than 1 (0dB)
acha hota h dikhne me
It has to have resistors but an active filter will alsol have an active device, usually an op-amp, while a passive filter has only passive components and needs no power supply.
In electronics any device that just pass along a signal by its characteristics is defined as passive.