I traced a loud, varying pitch, squealing and chirping noise (at idle) to the water pump after replacing all the belts on a 1994 22RE. I originally suspected the Power Steering pump or tensioner pulley. After taking off the power steering belt, running the engine, and getting the same sound, I turned the water pump pulley by hand and, sure enough, that's what was squeaking and chirping.) After buying the pump from Carquest (good quality parts), I called a Toyota dealer's parts department and asked them about the torque spec. (since there are so many variations listed on the internet and in the cheap repair manuals). They said to TORQUE THE 10mm HEAD NUTS AND BOLTS TO 13ft-lb, AND THE LONG 12mm HEAD BOLT TO 14ft-lb. I followed this advice, and the pump seated very nicely, squeezing the thin bead of non-hardening sealant out the sides a touch, just like the original. No coolant leaks. I used Wurth DP-300 gasket sealant on both sides of the gasket.
40 lbs on the water pump bolts
The 1999 Ford Ranger 3.0 liter water pump bolt torque specifications are 40 pounds. You do not want to torque the bolts to hard or they will break.
The long bolts need to be 20-30Nm, and the short bolts need 14-18. That's straight out of Gregory's repair manual.
18 ft lbs, 24 NM
For all 1992 Dodge Dakota V6 andV8 engines:All of the water pump bolts are to be torqued to 30 ft. lbs.For 1992 Dodge Dakota 4 cylinder engines:Upper bolts are torqued to 21 ft. lbs.Lower bolts are torqued to 40 ft. lbs.Waterpump housing-to-cover bolts are torqued to 105 inchlbs.
torque setting for 91 cadillac water pump 4.9 engine?
usually mechanics torque head bolts to 58lbs that is one of the main cause of blown head gaskit due to powerful engine. it should be torqued to atleast 67 lbs. i have it on my 87 turbo with no problems.
the torque you want to put on the water pump bolts are about 60 foot pounds of torque.
According to the chilton manual the 5 water pump bolts torque to 89 inch pounds. The four bolts that hold the water pump pulley torque to 18 foot pounds.
Hi i wannw know the torque specifications of the water pump in a 2003 dodge magnum 4.7l.Thanks,eric.
100 Nm (74 lb ft)
The torque should be around 11 ft-pounds