Quality of the earth pit needs to be checked and enhanced. Check the continuity of the earth bus/ conductor, check for improper joints in the earth bus / conductor and correct it. Earth resistance will reduce and the voltage difference between neutral and earth will also reduce.
Check also for the loose or floating neutral and correct it.
The formula to use is, phase voltage /1.73 = phase to neutral (ground) voltage.CommentThere is no such thing as a 'phase to phase', or 'phase to neutral' voltage. The correct terms are 'line to line' and 'line to neutral'. So the above answer should read: line voltage/1.73= line to neutral voltage = phase voltage.
A grounded neutral will be at earth potential. A floating neutral will be at a voltage dependent upon the voltage imbalance between phases, and the design of the transformer.
Yes,when the neutral potential is at ground potential i.e., 0v.
220
There should be no voltage on the neutral wire to ground. This is a serious situation. Call a qualified electrician to check this out.
The formula to use is, phase voltage /1.73 = phase to neutral (ground) voltage.CommentThere is no such thing as a 'phase to phase', or 'phase to neutral' voltage. The correct terms are 'line to line' and 'line to neutral'. So the above answer should read: line voltage/1.73= line to neutral voltage = phase voltage.
A grounded neutral will be at earth potential. A floating neutral will be at a voltage dependent upon the voltage imbalance between phases, and the design of the transformer.
Yes,when the neutral potential is at ground potential i.e., 0v.
Neutral is the return of the voltage not used by the appliance
220
There is normally no voltage on the neutral line because the neutral line is grounded. However, and this is always important, do not assume that neutral is grounded, nor that there is not an elevated voltage on neutral or ground due to a possible ground fault.
It shouldn't. The open end of a non connected neutral should have the same potential as the voltage feeding the circuit. The only time a voltage will show is when the return neutral is tested with a meter to the neutral bar or the ground return bar. It will then show what the supply voltage to the connected load is. Once this neutral is connected to the neutral bar there will be no voltage shown across the test meter between the neutral and the neutral bar or the ground bar.
yes
There should be no voltage on the neutral wire to ground. This is a serious situation. Call a qualified electrician to check this out.
An 11,000 volt three-phase supply has a voltage of 6351 from live to neutral, when there is a neutral wire.
There should be zero voltage between neutral and ground.
From line-to-line (any two of the three leads) voltage or 'line voltage', the voltage is 208 V. The line-to-neutral (one of the three leads and the neutral conductor), or 'phase voltage', is 120 V.