I'm no expert but i do know that you can't buy just the bearings at the part store...you have to purchase the whole hub assembly. as far as the required tools i do know that the spindle nut requires a 35mm deep well socket and all the other sockets you need are i believe larger than 15mm but i can't recall off hand the exact sizes...you will also need a punch or strong screwdriver to put in the rotor to stop it from spinning while removing the spindle nut...there is also an axl remover tool required to push the axl through once you remove the spindle nut and washer
Cam bearings, Rod and Main bearings. That will be all of the bearings required to replace when rebuilding a 350 engine.
It has 1 big hub bearing per side and you can not service them. It has factory sealed bearings. If there bad then you must replace the bearing.
You need to check all 4 wheel bearings. REPLACE AS NEEDED
how to replace a heater core in a 1997 Chevy blazer
Replacing a wheel bearing in your Chevrolet blazer will cost approximately $175 per bearing. You can save $125 by doing the work yourself.
If you are here looking for the answer then you to invest in a chiltons repair manual for the vehicle cause it is a job that is or could be very complicated.
How do you replace fuel injectors on 2003 Chevy blazer?Read more: How_do_you_replace_fuel_injectors_on_2003_Chevy_blazer
how do you replace seatbelt retractor on a 2000 chevy blazer
where is the blower motor on a 2001 chevy blazer
Its not your bearings you idiot its your brakes. Take it in and have them replaced.
how do you replace dome light in s10 chey blazer?
No. Removing the fuel tank from the vehicle is required.