Want this question answered?
what tools do i need to remove the wheel cylinder on a 1993 pontiac bonneville
you have to remove the tranny and clutch! 4-6 hours depending on who and where you get it done and the tools they have most people charge about $70/$80/hr
tools and knowledge (or a manual)
Probably basic hand tools and perhaps a brake spring tool. If you pick up a shop manual for the car and read their directions, you should get some idea what you'll need.
you need lots of tools to do that then take it out carefully
Normal metric mechanics tools. No special tools are needed other than what any mechanic would own.
Go buy a manual from your local parts store. Like most auto repairs, it involves multiple detailed steps. Read up on what you need to do, and which tools you'll require. After that, decide whether you have the skills, time, and tools to undertake it.
Replacing the blower motor resistor on a 2000 Pontiac Sunfire is a bugger of a job!.This project is far easier if you remove the blower fan first. You may be able to do it leaving the fan in, but you have to be an elf with very good eyesight. Tools required: 1/4" driver with a universal and a short 5.5 mm or 7/32" socket. First remove the wiring harness and the visible screw. Here's the tricky part! The rear screw is out of sight, and you have to push the floor liner down to get the socket attached. Once you get the 2nd screw out, simply remove and replace with the new one, reinstall the fan motor and your back in business. Hint: If you are not agile, or you are a large person, remove the front passenger seat. It's only 4 nuts and it will save your back. Martin Drost- Taber, Alta Canada.
what tools do i use to change the front brakes in my 2003 Pontiac grand prix
with tools
Try a 3/8" hex socket or a 9mm hex socket. The latter may be hard to find as they are usually dealer specialty tools. The 3/8" hex should work fine as long as the bolt heads are not rusted badly. Be careful not to strip the hex heads on the caliper. I found out the hard way.
Hey David==This is an involved procedure requiring many spedial fixtures and tools. If you want to tackle it get a shop manual from the parts store and get after it. Goodluck Joe