Acura Legend

What tools do you need to change a fuel filter for 1991 acura legend?

212223

Top Answer
User Avatar
Wiki User
2011-09-13 14:34:16
2011-09-13 14:34:16

Nothing special, just two open end wrenches. Not sure but around 1/2 in. You may need a Phillips screwdriver to get the mounting clamp off.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

what kind of tools do i need to change a fuel filter on a 2000 cougar

User Avatar

If you have the tools and the knowledge, yes

User Avatar

oil filter toolYou would need a oil filter wrench, a jack that's all you need to change the filter.

User Avatar

To change motor mounts on your acura you need the following tools. A philips head screwdriver and 7 mm socket on wretched. Using your phillips head screwdriver undo the srews and put the new mounts on their places.

User Avatar

Take off the fender or reach under. Give youself time and make sure you have the proper tools.

User Avatar

there's 2 of em (left and right). just pull up the silver engine cover (no tools) then release the latches on each filter and replace. can be done in 2 minutes with no tools. :)

User Avatar

Calibration tools are expensive, and these things might have to be ordered from the manufacturer.

User Avatar

You'll need a wheel chock, catch pan. a fuel line tool and a new fuel filter.

User Avatar

Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.

User Avatar

17m socket or spanner for the sump plug and oil filter for those wanting metric and its easier to get the oil filter off from the bottom not the top    

User Avatar

the fuel filter is on the frame rail drivers side ahead of the rear wheel, you will need fuel connector separation tools but its pretty easy

User Avatar

change out all the spark plugs,oil and air filter including the oil filter located under the engine you will need a floorjack and some tools. you will also need a filter wrench1

User Avatar

YES, A line disconnect tool available at any parts store

User Avatar

Crescent wrench, funnel, pan & possibly an oil filter wrench if it's on there tight.

User Avatar

An oil filter wrench and a pan/container to collect the drained oil, and a socket set.

User Avatar

In between air filter and throttle body. Very easy to replace you don't even need any tools! Just unplug electrical connection and it has a metal clip that holds it in place.

User Avatar

the fuel filter is located under the trunk, next to the fuel tank, it just takes the quick release tools to un hook the ends. it has three fuel lines on it.

User Avatar

Do you have the right tools for the job? Purchase the repair manual or alldata.

User Avatar

19mm socket for the oil drain plug and a oil filter wrench if your not manly like me

User Avatar

Just a Ford retainer ring tool. They're relatively inexpensive at auto parts stores.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.