2006 Honda Element. Jack, lug wrench, 12mm socket, 8mm socket or wrench, 4" C Clamp. Break lug nuts, jack up vehicle to where tire is barely off the ground, loosen and remove caliper bolts on inside of caliper, break bleed valve bolt with 8mm socket or wrench, (brake fluid should start to bleed out a little bit) slide caliper off of pads and rest in a place that does not put strain on the brake lines, remove old pads from rotor, slide new pads in to place, open C clamp and put male end inside caliper opening and the other end on the backside of the caliper, slowly close until caliper sleeve has receded flush with the surface of the caliper, remove c clamp and slip caliper assembly back over new pads, replace caliper bolts and tighten accordingly. Helps to have another person for this next pary...Turn the key until just before it turns over or you can start the vehicle if you like, slowly push the brake pedal to the floor, when all the way down tighten bleed valve with 8mm socket or wrench, replace tire, tighten all lug nuts until tire spins slightly, lower jack, finish tightening lug nuts the rest of the way. Move to next tire, repeat.
One person with the proper knowledge and tools can replace brake pads.
Can someone help me with the same promble.. how do you change the front brake pads and what tools do you need to do the job
The tools you would need to replace front brake pads are, a wrenche (size varies depending on vehicle type), a clamp tool, and brake pads.
You will need a hoist, a socket wrench set and a torque wrench. You will also need the brake pads, brake fluid and brake grease.?æ
You do not need a torque wrench when replacing brake pads and rotors. Some of the tools needed to change the rotors and pads are the c-clamp, sockets, wrench, grease, and brake cleaner.
To change the brake pads on a 1991 Chevrolet Caprice, you will need some tools. You're going to need a c-clamp, a hex key or Allen wrench to remove the calipers, and a wrench to bleed the lines.
All you need is a screwdriver and a hammer.You just knock out the two pins on the caliper,change the pads and tap the pins back in.
with tools
Changing your own front brake pads can save hundreds of dollars. Tools needed for the job are a jack, the brake pads, lug wrench, socket wrench, and brake fluid.
There are several tools you will need to change the brake pads on your 2001 Dodge Durango. You will need a 9/16 socket wrench. You will need a screwdriver. You will need a needle nose pliers. You will need a lug wrench to remove the tire and wheel.
I believe you need 17 mm box wrench for that.
what tools are needed