answersLogoWhite

0


Best Answer

If it's a 4-spd the switch will be mounted on the side of the transmission.

If the car is an automatic...There is a combination "neutral safety-backup light" switch located under the center console on the passenger side.

User Avatar

Wiki User

โˆ™ 2009-03-21 02:08:11
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: What turns on the backup lights when you put a 1975 Chevy Corvette in reverse?
Write your answer...
Submit
Related questions

How do you fix the reverse lights on a 1974 Chevy Corvette when all the other lights anfd fuses work but when you shift in reverse you get no reverse lights?

the reverse light switch is either out of adjustment. or broken. new one should be fairly cheap


How do you change the brake light bulbs on a 1994 Chevy Corvette?

Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.


How do upgrade your driving lights on your 1989 Chevy Corvette?

== ==


How do you change the fog lights on a 1995 Chevy Corvette?

== ==


Why do your backup lights on your 1995 Chevy s10 not work?

replae backup light switch on transmission


How do you replace the horn on 1996 Chevy Corvette?

Begin by removing the wiring harness from your 1996 Chevy Corvette horn. Remove the horn retaining bolts. Reverse the process to install the new horn.


Why are the reverse lights not working on Chevy S10 after bulbs are changed and fuse is okay?

switch on the transmission which sends a signal to the reverse lights when shift is in reverse......... is shot. You need a mechanic.


Backup lights on 1995 Chevy lumina not working no power in the wiring what can I do to fix it?

Take it to the garage.


How do you get reverse lights to work on a 1999 Chevy Suburban?

If the reverse lights are not working on a 1999 Chevy Suburban, be sure to check the fuse panel. If all the fuses are in working order, check the wires for any loose connections. Faulty wires can result in little or no light input.


What was the The Chevy Corvette named for?

The Chevy Corvette was named for the corvette, a small fighting frigate. Mako shark


Your Backup lights do not work on on Chevy s10 standard transmission?

Fuse, bulb, or the switch mounted on outside of tranny casing.


How do you replace a starter on 95 Corvette?

Remove the positive cable from your 1995 Chevy Corvette battery. Remove the cables from the front of your old starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


How do you replace the heater core on a 79 corvette?

Remove the heater core water supply hoses from your 1979 Chevy Corvette. Remove the heater core retaining bolts. Reverse the process to install the new heater core.


Why are the backup lights on your 1985 Chevy pickup not working?

there is a switch either under the shifter or on the side of the trans that activates the lights when you put it in R. It needs adjustment or replacement


How do you repair replace a 1987 Corvette power antenna?

Remove the wiring harness from the bottom of your 1987 Chevy Corvette power antenna. Remove the power antenna retaining nuts. Reverse the process to install your new power antenna.


My Backup lights do not work on Chevy s10 but bulbs are good?

well it seems to be a common problem it might just be the switch on the transmission


How much did a Chevy cost in 1963?

less then it does today how much did a Chevy corvette cost in 1963?


Why reverse lights don't work on 95 Chevy Cheyenne?

In those tail lights there is a circuit board. If it goes bad it will cause all kinds of problems.


How do you change the thermostat on a 1984 Corvette?

Remove the water supply hose from the top of your 1984 Chevy Corvette thermostat housing. Remove the thermostat housing retaining bolts. The old thermostat will lift out. Put the new thermostat in and reverse the process.


How do you change the radiator on a 1972 Corvette?

Drain the water from your 1972 Chevy Corvette radiator. Remove the radiator hoses. Remove the stabilizing arm retaining bolt. Remove the radiator retaining bolts. Reverse the process to install the new radiator.


How do you Replace starter in 1988 Corvette?

You should begin by removing the positive cable from your 1988 Chevy Corvette battery. Remove the cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.


What fuse controls the reverse lights on a 1995 Chevy lumina car?

There is nothing wrong with the reverse lights. It is probably your turn signal switch. They are bad in the 1995 lumina. If you do it yourself it should cost about 100 bucks. Good Luck!!


Reverse lights come on when brakes are applied on 2000 Chevy blazer?

Sounds as if the wires at the rear of the vehicle are mixed up. Check to see if the brake lights come on when put into reverse gear. That will rather confirm the hosed wiring.


My 2002 Chevy silverado duramax reverse lights won't turn on when I shift into reverse?

Try to replace the lights first. If they still don't work check the fuse. If that is good, it is most likely your back up light switch which is on the transmission(this is most likely your problem since both lights are out).


Brake light bulb 3057?

I don't understand...what's the question? Yes, that's a fairly common bulb size for tail lights or backup lights in late 90s and on autos. I have the same bulbs in my wife's Chevy S10 Blazer. Wagner 12V 3057 bulb. I don't understand...what's the question? Yes, that's a fairly common bulb size for tail lights or backup lights in late 90s and on autos. I have the same bulbs in my wife's Chevy S10 Blazer. Wagner 12V 3057 bulb.