regular 87 unleaded gas from any gas station. if it is a 4cycle then you will not have to mix gas and oil, only 2 cycle engines require mixing the oil and gas. (this is the same for edgers, weed whacker (weed eaters) any kind of gas powered lawn equipment.
The way to drain gasoline from a Briggs and Stratton lawn mower is to take the oil cap off and drain the oil. From there, run a rubber hose into the drain and siphon the rest of the oil and gas out.
It is a 2-cycle 4HP Briggs motor.
Assuming you are talking about lawn mower engines, it is located on top of the gas tank. The gas tank is of course where the gasoline is poured into.
4
The coil is under the cowling on top of the motor where the flywheel is.
You should always have 20 fluid ounces of oil in a Briggs and Stratton 5.5 HP lawn mower. This equals out to roughly 1.6 quarts.
One can purchase parts for a used Briggs and Stratton lawn mower from the following sources: Mower Graveyard, eBay, Briggs and Stratton, Zangler Repair, Lowes, Discount Online Parts.
which 42" Craftsman riding mower is made by Huskvarna
Where is the location of the idle screw on the Briggs and Stratton 6.0 engine mulcher mower?
0.030 is the gap for briggs and stratton 4.5 hp mower
official site for Briggs and Stratton Spark Plugs is: http://www.briggsandstratton.com/maint_repair/routine_maintenance/choosing_spark_plugs/ The proper spark plug will depend on the type of 6.5 HP motor that you have. Briggs and Stratton made several different ones and the best way to get the proper plug will be to call an authorized Briggs and Stratton repair shop with the mower make and model numbers.
how much would it cost to bore out a 12 hp briggs and stratton riding mower motor