SAE J1703 or FMVSS № 116 DOT3 Brake fluid. If you are doing a system flush buy at least a quart, it will take that much to get all the old fluid out, after removing all old fluid from master cylinder ( a turkey baster works well for this but don't reuse it as a baster) and bleed all for wheels, re fill master cylinder... again and again until fluid comes out clean and no air. If the master cylinder is just a bit low, a very small can of fluid will do to top it off. (note: a 2006 should not need a system flush as regular preventative maintence, unless it has become contaminated, but if you are doing a brake job, pads and/or shoes in rear, might as well go ahead with system flush.
Where is the brake fluid filler located on a 2004 Toyota Corolla?
When refilling brake fluid it is important to use the correct type of fluid for the car. For a 1995 Toyota Corolla the correct fluid is brake fluid dot 3 or brake fluid dot 4.
same as brake fluid resevoir
The fluid in the clutch master cylinder is brake fluid. Use DOT 3 or similar brake fluid for fluid replacement.
Dot 3
it says on the master cylinder cap. it should be Dot 3 brake fluid
Check owner's manual! Important to use right fluid.
Check your brake fluid level.
Firewall driver's side its on the top by the strut tower it says brake fluid... take off the black filler cap and install new brake fluid in reservoir
coolant, motor oil, power steering fluid, transmission fluid, brake fluid?
In most vehicles it's a small reservoir on top of the master cylinder.
Buy a bottle of DOT 3 brake fluid. Find the reservoir, which is in the engine compartment right in front of the brake pedal. Clean the reservoir, open it and add fluid until it reaches the bottom of the filler neck.