1986 DODGE TRUCKS D100 2WD PICKUP 5.2L 8-cyl Engine.
There are 2 fram filters that they say will work they are PH43 & DG43.
You can also use Wix Filters there are 3 that match up with the fram numbers above, they are 51068, 51307 & 51521
It you would like to check them out here are the sites. fram site will not allow you to search out your truck be make model and year where as the Wix site will. I know which one I would pick.....Wix Hand down. Had to use the Wix number to get you the fram number.
Please See link to the Wix Filter selection and select the correct filter for your Truck since I picked 1986 out of the air
The horsepower of a 1967 Dodge D D100 is approximately 258 hp.
hi i have dodge sweptline d100-1969 please i need chromrear bumper thanks hussain440
Yes your throttle body is interchangeable, just make sure that all connections are the same, especially the electrical; you can make changes to fuel inlet & vapor return just don't get them mixed up. Use a new base gasket & you can gain a little torque by adding a phenolic(Hard Plastic) spacer between the manifold & throttle body.
I have a D100 with a 318ci in it & the timing is 0.TDS with the vac advans unhooked & pluged. hope thes helps, Josh According to my sticker under the hood on my w100 w/ a 360 it should be 5.btdc, Brandon
the fuel filter is located inline on the inside of the left frame rale just ahead of the crossmember
I am not sure of how to instal a rear main seal on '89 dodge D100 with a v6.
225 slant six engine? Could be a leaky oil pressure sending unit located just below the oil filter.
10w30
5x5.5
Your D100 came with a 8 1/4 axle
Should be an A727 tranny. I have an 1989 Dodge D100 3.9 v6 and the transmission in it is an 904 a lighter version of the 727.
I have the same year just replaced mine with a wire harness from a d100 in the junk yard