0
The conductors on and in the lighting fixture should have an insulation rating of 105 degrees C. The supply conductors to the junction box that the fixture is hung from or connected to should have an insulation rating of 90 degree C.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
What type of wiring has copper foil conductor strips mounted on a plastic or fiber base?
The stubby J-shaped or L-shaped legs is the type of wiring has copper foil conductor strips mounted on a plastic or fiber base.
How do you wire plunger lamp holder of fluroscent light fixture?
It sounds like you are describing either a slimline or dc recessed base type of fluorescent fixture. There is a wiring diagram on the ballast of both of these types of fixtures. Do your wiring the same as what is shown and you will have no problem.
What type of conductors shall be used for wiring on fixture chains?
The type of wire you are looking for is called lamp cord. It comes in different colours usually to match the fixture. Fixtures hanging from chains use a clear insulation so as to blend in with the fixture chain colour. Remember that the smooth wire of the lamp cord connects to the hot wire and the ribbed wire on the lamp cord connects to the neutral wire in the ceiling junction box.
What type of dimmer switch should be used for a fluorescent under cabinet strip lighting?
It depends on the fixture. Some fluorescent bulbs won't work at all with a dimmer. The safest thing to do is to contact the fixture's manufacturer.
Is a copper conductor or a insulators?
Copper is a conductor of electricity.
What is a pin based fluorescent light fixture?
A pin based fluorescent light fixture is the type of fixture that takes fluorescent tubes. On each end of the fluorescent tubes there are contact pins. These pins are used to hold the tube in the fixture and to supply the voltage to the tube from the fixture's ballast.
Which of the following is not a type of store fixture Roof Racks promo tables spinners or 4-way?
Roof racks are NOT a store fixture.
What type of metal is best conductor?
Silver is the best conductor
Can you convert a 2 prong plug-in light into a hard wired fixture?
Sure, sounds like a creative way to use an old favorite table-top fixture and save a few bucks too. There would be a few things I would consider. First and foremost, be sure the "2 prong plug-in light" is made for outdoor use if you plan to mount this outdoors! Secondly, how are you going to securely mount this fixture to a ceiling or wall? Designing a custom base, may end up being more trouble than it's worth. After installation the fixture should be flush against the surface, and everything tucked inside. Next, I wouldn't forget, or leave out the ground. Even it is a 2 prong light. If your going to mount this on a wall, ceiling, or anywhere, chances are you already have a hole cut out and "2-conductor with ground" Romex type wiring ready at the instillation area. Where to attach the bare ground wire, maybe too risky if the fixture is not an metal chassis. Note: Assuming that there will only be one fixture on this branch circuit, then go with a gauge of Romex similar to that of the fixture cord. If using many in series or parallel , reference a NEC handbook for detailed guidance.
How do you wire a ballast that has two black wires for a one tube fluorescent lamp?
There should be a black & white wire coming from the light. Hook black to black and white to white. Then connect the ground wire to the light chassis. You need 12/2 with ground for the circuit. You do not need a light fixture box for these type lights.
What type of circuit is it that has a hot conductor contacting a neutral conductor?
A shorted circuit.
Where is Fluorescent light wiring diagram?
For information about fluorescent tube lights see the answers to the Related questions and the Related link shown below.
