answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What type of lubricant can be used on an oven door to keep the light switch from sticking?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does the door alarm still continue to beep when the door is closed?

The switch inside the door is sticking- a common problem. Use some Brake cleaner Spray to clean the switch near the door latch at the door jamb. After cleaning it, spray some WD40 or similar lubricant on it. Ths usually fixes if for a few months and then do it again in about 6 months. The switch inside the door is sticking- a common problem. Use some Brake cleaner Spray to clean the switch near the door latch at the door jamb. After cleaning it, spray some WD40 or similar lubricant on it. Ths usually fixes if for a few months and then do it again in about 6 months.


What causes your 2004 ford explorer to beep that a door is open and the dome light on when all doors are properly closed?

Possible faulty door switch. Try contact cleaner or light grade of lubricant on the switch. Push each door switch in by hand and see if door ajar light goes out.What_causes_your_2004_ford_explorer_to_beep_that_a_door_is_open_and_the_dome_light_on_when_all_doors_are_properly_closed


Why does the drivers courtesy light and ignition light and chime work at times 1991 accord ex?

Probably a sticking door switch, give it some wd40. The switch should be where the door hinges.


Door ajar light on dash is on after all doors are closed?

Possible faulty door switch.Try contact cleaner or light grade of lubricant on the switch. Push it i nby hand and see if door ajar light goes out.


Why doesn't the door ajar light work on a 1991 Acura Integra LS special?

either the light is burned out or the door switch is sticking or malfunctioning. there in a screw right behind the switch on the frame where the door latches pull the little switch back and there is a screw there take it out and check the contacts they could also be dirty


1991 Buick Park Ave interior lights stay on all the time why?

There is a switch in the door that tells the car's computer system that the door is closed...because most cars leave the interior light on until the door is closed, if the switch is jammed the car will leave the light on all the time. Try spraying the switch with WD-40 or some other lubricant, and then opening and closing the door several times to work the lubricant in. The switch is a small metal button located on the side of the door where the hardware connects to the main body of the car when the door is closed. If that doesn't work you may have a bad switch or other electrical problem.


How do you fix door ajar light that comes on when doors are closed?

The most likely cause is a sticking or faulty door switch. In much older cars, there is a spring loaded switch that the door makes contact with when it closes and shuts the light off. If you have a much older car, the switch may be worn out. In most cars from 1990's on, the switch is built into the door latch (this is the latch that grabs onto the metal ring that is bolted to your cars door opening. If so, it may just be sticking. Use some electronic cleaner to clean the switch and then use a lubricant to lubricate it. Note: Don't use WD-40. WD-40 is meant to be a penetrant. It will quickly get sticky and your switch will stick again. check and see of the switch in the hinge of the any of the doors have been dislodged or the wires connected to them disconnected or broken some doors have small brass buttons that have to connect there is a screw type adjustment on them as they must make contact for the light to go out if this does not work the spring inside has collapsed and the whole button must be replaced


Where is the switch that controls the dome light when the door is open on a 1990 Z24 as the dome light and seat belt light come on intermittently while driving?

check the drivers door jam area you should see a little tab sticking out it pushes in and out when opening and closing the door that triggers the light


Answer Why are the interior dome lights on a 1999 Ford Ranger staying on with the door closed?

Just to the right of your headlight switch is a gauge lighting dimmer wheel switch , if that has been rotated all the way up it turns on your courtesy lights when the doors are closed. Also , if a door ajar light is on in your gauge cluster you probably have a sticking door ajar switch


Why does the cab light stay on after my doors are closed on my 1997ranger?

To the right of the headlight switch is a gauge light dimmer wheel , if that has been rotated all the way up , your courtesy lights will stay on with the doors closed. If you also have a door ajar light lit up in your gauge cluster , then you may have a sticking door ajar switch , or something isn't closed properly


95 Ford Ranger XLT disconnect the chime?

Is your chime continuing after cranking vehicle and door is closed. If so, there is an electrical switch in the door that gets stuck. Use a spray lubricant inside the door latch to free switch.


Dome light on 1999 Ford Ranger always on?

Just to the right of your headlight switch on your dash , is a gauge lighting dimmer wheel switch . Check to see if that has been rotated all the way up. If it has , that turns on the courtesy lights when the doors are closed If you also get a door ajar warning light in your gauge cluster , you probably have a sticking door ajar switch . The door ajar switches are inside the doors , on the backside of the latching mechanism .