Headlights Tail and Brake Lights
Nissan Armada
Toyota Tacoma

What type of taillight bulb does a 1999 Tacoma need and how do you replace it?

666768

Top Answer
User Avatar
Wiki User
2006-01-21 23:17:46
2006-01-21 23:17:46

Go to the WWW address below. The tail light is mounted with 4 screws. http://www.sylvania.com/ConsumerProducts/AutomotiveLighting/LampReplacementGuide/

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you replace a taillight on a Honda 2002 Civic?

User Avatar

Remove the taillight assembly to gain access to the bulbs

User Avatar

Open rear hatch, there are two screws in taillight lens, take them out, the lens will lift out, turn the socket and it will relese, replace bulb, (I would recommend using some dielectric grease on bulb socket while you have it out), replace in reverse order. AJ

User Avatar

my 1997 Toyota Tacoma has the dash/gauge light burnt out - i would like any help to locate bulb and replace i thank you

User Avatar

Taillight bulb replacment/Taillight housing replacement * Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops

User Avatar

* Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops

User Avatar

How do you replace a 1999 Ford Escort headlight bulb?"

User Avatar

You can access the bulb from the trunk area (from behind). Just remove and replace, should be straightforward.

User Avatar

rear you use a torx driver to remove taillight assembly screws. them replace bulb.

User Avatar

The light bulb or the taillight lens? Open the trunk to replace the bulb.

User Avatar

* Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops

User Avatar

peel bak the carpet in the he rear of the light assembly unit, there are two clips to be moved and the unit pops out. replace the bulb and reassemble

User Avatar

to change the bulb you go in from the backside, if its burned out you only need to replace the bulb. its similar to replacing a taillight bulb

User Avatar

Pull back the carpet and remove the 2 plastic "wing nuts". This will allow the entire taillight assembly to hang loose. Remove the bulb assembly by turning it 1/4 turn and replace the bulb.

User Avatar

Release the two tabs you can't find!

User Avatar

take the screws out if the tail light and pull the old one out

User Avatar

I have a 1999 intrepid. Once you unscrew all the plastic wingnuts from the taillight assembly, the taillight slides out but is a tight fit. I pulled on it from the trunk lid side and found it came out easier. When you change your light bulb, it also helps to replace all of them in the taillight assembly all at 1 time. I did just 1 bulb then a second bulb went out, but since replacing all of them at 1 time, I have not had any go out since. I hope this helped you.

User Avatar

Inside the trunk on either side of the car are entry panels to the taillights. Remove the cover and unscrew the bolts that hold the taillight onto the back of the car body. Remove the taillight assembly and replace bulb(s).

User Avatar

* Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops

User Avatar

To replace the rear bulb in a Toyota 4Runner remove the plastic covers located in the trunk. Taking off the plastic covers will reveal the taillight housing and bulbs. Replace the bulbs.

User Avatar

If you can't get to the back of the light assy you have to remove it from the vehicle and the bulb screws in.

User Avatar

how to change a taillight in a 2008 Nissan maxima

User Avatar

remove two screws, remove tail light, remove bulb. reinstallation is the reverse of removal.

User Avatar

remove the 2 t15 screws in the taillight remove the assy. turn bulb socket out and replace


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.