answersLogoWhite

0


Best Answer

It sounds like you have encountered a security screw. Product manufactures put these screws on pieces they would rather you not mess with. You can buy a kit with different driver bits for various security screws at most tool and hardware stores. Be careful with anything you find once you remove that screw, it is likely there to prevent you from damaging the product or hurting yourself.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

8y ago

It depends on the screw.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What type of tool is needed to remove a screw with a post in the center that looks like a Phillips head?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove a t15 screw?

You go to the local hardware store and pick up a torx bit driver for a t15. It looks like a screwdriver with a starbit head instead of a flathead or phillips.


How do you remove the right turn signal lamp assembly from a 2002 Mazda MPV specifically the plastic fastner that looks like a Phillips head screw from the top?

Get a flat head screwdriver and pop the center round plastic head up. Once it is raised you can pull the entire plastic fastener up. It comes out reather easily.


What actors and actresses appeared in Last Looks - 2004?

The cast of Last Looks - 2004 includes: Dana Keller Donogh Phillips


1966 mustang how do you remove wiper switch on dash-thks?

Remove the knob with a small Allen key. Underneath looks like 2 flat screwdriver slots intersecting, almost like a Phillips head, with the shaft for the knob in the middle. I find it easiest to remove with needlenose pliers. Just unscrew and the switch will come out.


What socket is needed to remove 91 cavalier wheel cylinder bolts looks like reversed torx?

Any type of socket can be used to remove a 91' Cavalier wheel cylinder bolt that looks like a reversed torx. However, make sure the socket is a bolt head socket.


Whereismainfuse boxfor 1977 Honda goldwing gl1000?

THE MAIN 30AMP FUSE IS LOCATED JUST RIGHT OF THE BATTERY BOX. MINE IS JUST A LITTELOWER THEN CENTER IS ATTACHED BY A METAL CLIP.IT LOOKS LIKE A SMALL BLACK BOX. YOU WILL NEED TO DISCONNECT THE ELECTORIAL CONNECTOR AND OPEN THE FUSE BOX. YOU CAN REMOVE THE PHILLIPS SCREWS SECURING THE FUSE AND THEN REPLACE IT. HOPES THAT HELPS. JOHN


Where is the center of universe located and how far is it from solar system?

It seems that the Universe has no center. It is generally believed that the Universe looks roughly the same way wherever you are; wherever you are, it looks as if you are at the center.


You are a 54 years female have a bony protusion in the center of my forehead for the last 20 yrsit is not painful but looks uglyi want it to gohow do you go about it?

ask your doctor if he can surgically remove it.


Where is the center of your universe?

It is commonly believed that there is no center - or, in other words, any part of the Universe looks like it is the center.


What did the inside of the san juan capistrano mission look like?

MISSION SAN JUAN CAPRISTRANO LOOKS LIKE A CHUCH AND A LEARNING CENTER . MISSION SAN JUAN CAPRISTRANO LOOKS LIKE A CHUCH AND A LEARNING CENTER . MISSION SAN JUAN CAPRISTRANO LOOKS LIKE A CHUCH AND A LEARNING CENTER . MISSION SAN JUAN CAPRISTRANO LOOKS LIKE A CHUCH AND A LEARNING CENTER .


Where is the oil drain plug on a 1985 Yamaha FJ600?

look at the below the oil filter. It is a 19mm bolt that faces the front tire. in the center of the bolt it looks like there is a Phillips screw. The bolt is underneath the engine block between the exhaust pipes. good luck!


Why do most bras have a ribbon or flower in the center?

It looks sexy.