0
What weight oil goes in a front spindle of a 95 polaris xplorer?
Wiki User
∙ 11y ago
5W20 Synthetic, Type f Synthetic trans fluid, or the recommended Polaris premium demand drive fluid.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the vin on a Polaris xplorer 400?
The Vin number on a Polaris Xplorer 400 is located on the Manufacturer`s sticker that is located on the front plastic just below the oil filler cap. If the sticker is missing you can find the numbers on the frame on the right side of the quad just in front of the engine.
Where is location of battery in Polaris xPlorer?
the battery on a polaris explorer should be located under the rear fender above the left rear tire. if it is not there, it will be almost directly under the gas tank, in front of the engine
How do you change front brakes on a polaris sportsman 500?
how do i change front brake pads on my 2002 polaris 500 sportsman
What is a spindle on a 1995 Chevy corsica?
The spindle is what the front wheel is mounted on. It is the shaft that the wheel bearing slides up on.
Where is the spindle on a 1995 ford explorer XLT?
The spindle is an assembly that is part of the front suspension at the front wheels on a 2 wheel drive , on a 4X4 it is called the steering knuckle. There is 1 for each front wheel
What is the socket size for front spindle nuts on 2000 impala?
I have owned my Impala since it was new, nothing has been changed and the perfect fit for the original front spindle nut is 35mm.
What polaris snowmobile has a rounded front?
the edge or the switchback
Does an imaginary line drawn from the 2 stars at the front of the Big Dipper lead to Sirius or Polaris?
They point at Polaris.
How can you find polaris using the big dipper?
The two stars in the front of the bowl of the Big Dipper point to Polaris.
What size is front spindle nut on 2003 durango slt 2 wheel drive?
The front spindle nut size is 36mm on a 2003 Durango 2wd. I found this out after 3 trips to the parts store...
How do you replace the front wheel bearing on a 1996 mercury villager?
The front wheel bearings must be pressed into and out of the spindle/hub assembly. You will need to take the spindle assembly to an automotive machine shop to have this done.
What is the size of the front spindle nut on a 2003 Sebring Sedan?
32 mm
