50hz
Voltage amplitude is the maximum value of a voltage.
Amplitude
Voltage and frequency are independent quantities.AnswerBecause the r.m.s. value is dependent on the shape of the waveform, not its frequency. The average value of any symmetrical waveform is zero and is independent of frequency.
at low frequency less than 50hz the voltage gain decreases with decreasing frequency and at mid frequency{50hz to 20khz} the voltage gain is uniform because resistor value are independent of frequency change and at the high frequency votage gain falls.
Peak inverse voltage of a device like diode gives the maximum value of voltage that it can withstand without being damaged when it is reverse biased.
Voltage amplitude is the maximum value of a voltage.
An RF cable is an electrical connector designed to work at radio frequencies in the multi-megahertz range. Breakdown is a function of maximum voltage. Maximum capabilities is dependent on frequency since the typical value of VSWR is proportional to the increase in frequency.
Alternating voltage is the E.M.F. and is one whose magnitude whose magnitude changes with time and direction reverses periodically. The instantaneous value is given by E=Eo sin w t, where,E=value of alternating voltage at time t Eo = maximum value of alternating voltage(amplitude) w=angular frequency of supply.
Amplitude
define the maximum value of an ac wave form
Range = Maximum value - Minimum value
It is the highest value of the amplitude, called the peak value. Scroll down to related links and look at "RMS voltage, peak voltage and peak-to-peak voltage". Look at the figure in the middle below the headline "RMS voltage, peak voltage and peak-to-peak voltage".
Voltage and frequency are independent quantities.AnswerBecause the r.m.s. value is dependent on the shape of the waveform, not its frequency. The average value of any symmetrical waveform is zero and is independent of frequency.
The spread is the minimum value (not count) to the maximum value. The range is the maximum value minus the minimum value. Spread does not consider the frequency of the values, only the minimum and maximum.
maximum or peak value
at low frequency less than 50hz the voltage gain decreases with decreasing frequency and at mid frequency{50hz to 20khz} the voltage gain is uniform because resistor value are independent of frequency change and at the high frequency votage gain falls.
For a low frequency source, the voltage across the inductor tends to zero because its impedance is proportionnal to source frequency, whereas the voltage across the resistor tends to the voltage source value.