0
you most likely have a horrible fuel sensory causing your car to be bad at idling. also you may hvae reved your engine to hard and that is causing it to idle.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What does code 1554 mean on a 1996 Chevy 1500 truck?
P1554 Cruise Engaged Circuit High Voltage
What would cause ac control switch to only work on med-high and high speed for a 1996 Chevy ck1500?
worn blower motor
What would cause a 1996 Chevy Corsica to idle high then idle fine after turning the engine off and on again?
check the soleinoid
Why could cause a 1996 Chevy Cavalier to idle high after fixing a warped head?
You probably have a vacuum leak. Check intake manifold and throttle body gaskets as well as vacuum lines.
Chevy 1500 4X4 will not shift into FWD?
In my experience Chevrolet 1500 4x4 dosent have a front wheel drive option. You should be able to drive in 2wd, 4wd high and 4wd low but no FWD.
Why do your ac blower only work on high on your 1996 Chevy impala SS?
faulty blower motor resistor
Will speed sensor on Chevy S10 blazer cause it not to shift into high gear?
Yes, it could.
1989 1500 Chevy transmission?
ANSWERED----SEE--------,,, 1989 1500 Chevy transmission repair. I have a Chevy and I am having trouble with the transmission-----------Good luck, Jamison if the transmission will not shift until it reaches high rpms you may need to adjust the tv aka throttle valve cable. If miss-adjusted you could burn the clutches and gears completely up
Can both the low and high beam head lights be turned on together in a 1996 Chevy Tahoe?
yes my brother has done it on several Chevy vehicles with that style head lights
1995 Chevy 1500 heater run on high only?
The blower motor speed resistor is burned out. That part is available from your local auto parts store.
Where is the orifice tube located in a 1994 Chevy 1500 pickup 5.7L V8 350?
it's located between the fire wall and condenser in the high side line...
Only high speed works on your blower motor of a 1996 jeep...what could be the cause?
Most likely cause is a failed blower resistor.
