The filament , once broken , will no longer generate any light because the connection is now broken and no longer conducting any electricity .
The light is absorbed and changed to tiny amount of heat.
When electric current flows through the tiny wire inside the light bulb, the electrical energy heats the wire so hot that it radiates light and heat. If the wire was in air, it would immediately burn up. But all the air has been removed from the light bulb, so the wire lasts for a while even though it's so hot.
A photon
light
So everyone could have light easily and won't have to carry around a candle. Which is a fire hazard! Light bulbs are important because there are actually thousands of tiny little bulbs on a computer screen that can project different colours and make a picture, in this case these words you are reading right now are actually little bulbs turned off because it's black. Plasma screens have like 1000000 (million) bulbs on it.
It is a very tiny wire, which is in a light bulb.
It is possible that it could cause a blockage in the intestinal tract if it is big enough. If it is tiny, then it should pass normally on it's own.
LEDS
The light is absorbed and changed to tiny amount of heat.
Well. A light bulb lights up because the atoms and electrons clash together which causes an electrical charge. And then it magically lights up the light bulb. By:?
Using a remote control similar to those ones used to turn on electronic devices. The infrared rays can switch the light bulb on, since it has a small transistorised circuit that can actuate a tiny relay to put the light bulb in series with the electric circuit.
I assume you mean in a miniature light Christmas tree light set. Assume a 60 bulb set designed for 120 volts. Each bulb has 120/60 or 2 volts across it when all bulbs are lit. But each bulb has a tiny insulated wire across the contacts inside the bulb. The insulation can handle small voltages, but not 120 volts, so when the filament breaks, the voltage on the dead bulb goes from 2 volts to 120, breaking the insulation and welding the wire across the leads. This newly welded wire then completes the circuit and the other bulbs instantly relight, now with 120/59 or 2.03 volts across each bulb, so they get slightly brighter.
They are changed by a lens in the light machine, They have a white bulb and change the slides to pass through the tiny holes to make it seem as if it was a laser.
Teeth
Bile.
Ice
Just spots of excrement that the bulb heats and causes to turn dark or burn.