answersLogoWhite

0


Best Answer

nothing, the starter will not engage, and the voltage bypass to the coil will not be energized.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What will happen if the two small wires were reversed on a starter relay?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the starter relay on the 1995 Ford Windstar?

It's actually on the starter, and it's the small cylinder attached to it. Windstar starters have a dual-purpose solenoid that not only engages the starter gear with the flywheel, but also acts as the starter relay.


What are the wiring connections for a starter relay on a 1993 Ford truck?

Battery to a large terminal Starter to other large terminal Trigger wire to small terminal (if you have an extra small terminal on new relay disregard)


Where is the starter relay on a 2001 Chevrolet Cavalier?

The started relay is located on the radiator reinforcment. It is a small grey box


What does a starter relay look like on a ford escort?

There is no starter relay on an Escort. The main battery positive cable goes directly to the starter. A small wire with a clip on it marked s goes to the solenoid. The main battery current to the starter is supplied with this solenoid.


Where is starter relay on 1990 fxstc harley Davidson?

Its located on the outside of the wheel well, behind the oil bag... a wire runs from your starter directly to the relay, which is a small inch squared black box.


How do you test the starter relay on a 1995 ford ranger?

Make sure truck is in neutral jump across small (trigger) terminal and cable that runs to starter if vehicle "turns over" relay is bad


Why does the starter stay engaged on ford 460 motorhome?

If your starter stays engaged it is either your stater relay (solenoid) or your ignition switch.It is usually the relay,either mounted on your inner fender(earlier system)or on the starter itself.Follow the positive cable (red) from your battery,if it goes directly to your starter it is the later system.To test disconnect the ignition wire on the relay,the small gauge wire.If there is 2 small wires on the fender mounted relay you can disconnect them both if your not sure witch is ignition wire.Leave the 2 large wires connected.If it still is turning over it is your relay,if it stopped it is your ignition.If you have the stater mounted relay remove the small wire from the "S" terminal,and repeat as above.


Why would a ford focus not even click when trying to start with a good battery?

Check if there is voltage to the starter "S" terminal (if starter does not have the small wire, ensure the starter relay is working). Go from there


Location of starter relay on a 93 acura legend automatic transmission?

Follow the + battery cable -jump the small terminal and the wire to the starter (Make sure in neutral) Starter should operate


What does a fuel pump relay switch do?

A fuel pump relay provides power to turn on fuel pump. A relay allows small current to control high current- example- a starter relay-- If you didnt have a starter relay- the big thick starter wires would have to run to the ignition switch, and then back to the starter. with a relay- you only have little tiny wires running to the ignition switch... when you turn the ignition switch on, a little bit of current goes through the tiny wires to the relay- which powers a coil- which then makes the contacts inside the relay connect- which then allows the high current to run through the big wires to the starter. kinda simple- but can be confusing. carmine C-


Where is the starter motor relay located on a 1988 Lincoln town car?

The relay, also called the starter solinoid, is bolted to the frame right next to the battery. Just follow your battery cables and they will lead you to a small round piece of plastic with three metal posts sticking out of it. This is the relay.


What wires go where on the starter relay switch of a 1990 Ford 150?

Battery connect to large terminal Starter connect to other large terminal Trigger wire (smaller) connects to small terminal If you have an extra small terminal disregard