answersLogoWhite

0


Best Answer

the wheel bearing will wear out. worst scenario, is the whell will fall off causing considerable damage ,maybe even a wreck. can also cause bearing to get hot , and weld bearing race to axle stub,requiring replacement of this hub it is not a big or expensive job to have a wheel bearing replaced. the ABS sensor is not on the bearing and will not need replacing if you replace the bearings

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What will happen if you continue to drive a car with a noisy and clicking front hub wheel bearing with abs sensor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a bad ABS sensor make a loud humming noise while driving down the road?

No. The loud humming noise could be a wheel bearing going bad and it could damage the ABS sensor if allowed to continue.


When changing front wheel bearing do you also have to replace the abs sensor to make the warning light go out?

The new wheel bearing includes the ABS sensor. They are not available separately.


How do you remove a speed sensor on 2004 Chevy Colorado?

If it is 4x4 remove axle from wheel bearing assembly and then remove the wheel bearing assembly. Make sure the tone ring (looks like a ring with teeth) is still attached to the spped sensor side of the bearing, if not, replace wheel bearing assembly with an assembly that comes with the speed sensor. Replacing a speed sensor without a tone ring is pointless because it won't work.


Where is the abs sensor located on a 2002 grand am?

The ABS sensor is located in the front wheel bearing. The is one on either side, so you will need a mechanic to pull the error code out of the car's computer to determine which side it is. You must replace the entire wheel bearing to fix the sensor, but chances are that if the sensor goes the wheel bearing is leaking. The wheel bearing is a sealed unit and should not leak, but over time, water, grime, and wear, it may begin to no longer be sealed. Buy a new wheel bearing and install it your self if you want. All you have to do is take off the wheel, the brake caliper, the rotor, and finally the bearing itself.


Where is the abs sensor in a 1998 Ford Expedition?

Might be part of the wheel bearing.


Where is the abs sensor on the opel zafira 2001?

it is built in to the wheel hub and bearing


How do you change a rear wheel bearing on a 2000 Pontiac Montana?

You need to replace the rear wheel hub - bearing and speed sensor inclusive


How do you change the ABS speed sensor on a 1993 Pontiac Bonneville also need to know the do's and do not's for this procedure?

The speed sensor may be built into the hub bearing. In that case the whole hub bearing needs to be replaced.


How do you install a gas sensor in a 1991 Lincoln Town Car?

what is a gas sensor never heard of one is it like a muffler bearing?


Where is located sensor speed by Nissan navara 2007?

Nearside front wheel bearing


Where is the ABS sensor on a 2001 Dodge Grand Caravan?

There could be on at each wheel bearing.


Where is wheel speed sensor 2003 rendezvous?

In the wheel hub along with the wheel bearing.