on big post you will have battery cable and a couple of fuse links on small post 1 wire
How do the starter wires go on a 95 sunfire2.2 engine
Disconnect battery, remove wires off of starter remembering where they go, then loosen two nuts holding the starter . Reverse to re connect/install
go to www.commandocaralarms.com/wiring/1996/Jeep/Grand-Cherokee and it will have a chart of wires and wire location. i have a 1996 there all the same.
The brown wire goes to the small lug on the solenoid. The red, and the black with grey stripe go to the large lug.
where do the wires on the starter go on a 1977 pontiac 400
First locate starter, once you've done that, then disconnect battery, go back to starter and lossen the 3 bolts that hold it in place, place with new starter hook up wires accordingly, then reconnect battery.
I am currently having the same issue. First unhook the battery completely. Then you need to find where the wires on the starter are connected to the battery. Detach the wires from the starter that go to the battery. Once you have the starter wires completely detached from battery you can start removal of starter from engine block.
the solenoid is on the starter. It's the part the wires go into.
The starter needs a large wire from the battery and a wire from the starter switch. These are connected to the solenoid that is attached to the starter.
its located where the tranny bolts up to the motor. disconnect the three wires from the starter, then take the three bolts out of the starter and pull it out. just remember where the wires go!!
The Starter relay for Acclaims are located right on the starter, its what the wires that go to the starter hooks to.
a starter on a grand prix is behind the engine which mean you must go under and find it. once under it will be very notice able.