A voltmeter connected across the broken (open) filament of a light bulb reads the
full voltage of the power supply whether the bulb is in a series or parallel circuit.
-- In a series circuit with other components in series with the bulb, this reading tells you
that at least one of the components is open, possibly the filament.
-- In a parallel circuit with other components in parallel with the bulb, or with
the bulb connected directly to the power supply, this reading tells you nothing ...
the voltmeter reads the full power supply voltage whether the bulb is open or good.
The voltmeter isn't a very helpful measurement to identify an open filament.
An ohmmeter, with the power to the circuit turned off, is much more helpful.
A light bulb works by passing an electric current through the filament, which is usually made from a high resistance substance such as tungsten. When the current flows through, the filament glows which produces the light. When it burns out, no electricity passes and no glowing occurs. Source: i just know
The filament , once broken , will no longer generate any light because the connection is now broken and no longer conducting any electricity .
If the bulb lights up then electricity is passing through the bulb. If the bulb doesn't light up then electricity is not passing through.
"Your jeans are broken " ok ? hhahahhahahah
Most units have a fan to circulate cold air and maintain the compartment at a uniform temperature. Without this, the cold air will settle at the bottom, and the thermostat will not get an accurate reading, leading to over-short or over-long cooling cycles. The fan could be broken, or part of the system that controls the fan (like the motherboard or a relay) could be broken. Additionally, the fan could have failed and taken out part of the electronics.
No, the broken filament breaks the connection which electricity needs to complete the circuit.
No, the broken filament breaks the connection which electricity needs to complete the circuit.
(Filament is a thread or thin wire.)Is the lamp unplugged or is the filament broken in the bulb?A silkworm's cocoon is made from a thin filament which can be twisted into thread.
Fused bulb
no, the circuit won't complete
A fused bulb does not glow because the filament of a fused bulb is broken. Since current can't flow through the filament, it can't get hot enough to glow.
Replace the fuse only when the filament inside the fuse is broken, In other words when it "pops".
Maybe, but not sure info would be useful. You can use ohmmeter to check that a tube's filament is intact. Broken/burned-out filament is most likely reason for dead tube.
A light bulb works by passing an electric current through the filament, which is usually made from a high resistance substance such as tungsten. When the current flows through, the filament glows which produces the light. When it burns out, no electricity passes and no glowing occurs. Source: i just know
The filament , once broken , will no longer generate any light because the connection is now broken and no longer conducting any electricity .
If the bulb lights up then electricity is passing through the bulb. If the bulb doesn't light up then electricity is not passing through.
Probably because the filament in the light bulb is broken or possibly there is a bad contact some where,