Want this question answered?
A damaged catalytic converter could cause that.
Could be spark in the motor, or the distributor and rotor need to be replaced.
A loose kill switch wire on your out board motor will cause the engine to lose power. As the kill switch loses contact the motor will begin to bog down or completely quit.
Depends on what sort of motor it was. If it was the sort you find in an ordinary electric drill, then it would slow down. But rememer, the only way you can reasonably reduce the current in to motor is to reduce the voltage in the supply. A motor takes what current it can, dependent on Ohm's Law. To reduce the current, reduce the voltage. But in a three-phase motor, the speed being dependent on the rotation of the phases, it would more or less stay the same. But this assumes it's not under load. A load would cause it to slow down.
U NEED A THERMOSTAT. THAT IS WHAT HOLDS THE COOLANT IN THE RADIATOR, SO IT CAN COOL DOWN BEFORE IT GOES BACK IN THE MOTOR.
Front or rear wheel drive same problem. Motor and or transmission mount. As the motor shifts on accelaration it can cause the shifter to move. I assume it is in the floor.
pre-ignition from excessive heat in combustion chamber. fatigue of internal components from lack of lubrication, namely rings seizing to cylinder walls.
It could affect it somewhat, but that's probably not the problem you're having with your AC. A system performance test with a manifold gauge set would narrow down the cause of your AC problem.
No.
the intake gaskets on these motors are known to break and coolant will run along the intake and head down the back of the motor.
The blower motor is tired. It will eventually blow a fuse and/or burn out the blower motor speed resistor. Time to replace the blower motor. Also check connections for high resistance damage (melted connections).
possible motor mount problem, when you turn the steering wheel- the wheels line up at a differant height and if the motor mount is totally shot then this cause the motor to bind with the tranny and or front axels depending on the car