0
What would cause a 2001 Chevy s10 to stall going down the road and not restart?
Wiki User
∙ 11y ago
I would suspect fuel pump failure.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What would cause your 90 Chevy lumina to stall out after it warms up It will restart but dies when put in gear.?
tcc switch on the top of the trans. Just unplug and drive away.
What can cause a Chevy Cavalier to stall?
with me it was the o2 censer
Can a cam shaft sensor problem cause a 2002 Chrysler Sebring to stall and not restart?
Yes.
What would cause a 1993 Jeep Grand Cherokee to start stall and then restart?
usually the factory alarm
What would cause your 1989 Chevy Berreta GTU 5 speed to sputter and then stall?
Could be a fuel pump going bad or a clogged fuel filter,
Will a crank sensor cause the car to stall out at any speed and then wait afew minutes and it will restart and run for a wile again until next stall?
replace iignition coil
What would cause a 95 Nissan 240 sx to stall while driving but restart with no problem?
Your a bad driver get a license
What would cause a 1996 Pontiac Grand Prix to stall while driving and not restart?
the problem may be that the timing chain or belt has broken
What would cause a 95 Chevy caprice classic to stall lose power not start?
a vac leak
What happens if you have a bad crank position sensor?
your engine will stall. When you try to restart the engine, it will stutter and stall again.
Why does an 88 Chevy truck shut off while you are driving down the road it does not stall spit or sputter it just dies will restart easily after each time it dies?
its a electronic piece in the key push ron area in the steering collum the key rod connectes it to complete the electric curcuit circle if it cracked it will cause it to shut down and restart by itself..
Where is a camshaft sensor on 2000 Chevy Tracker?
My 2003 Chevy Tracker would not restart when it was hot and finally would stall & not restart until it sat and cooled off for 10 minutes. It would crank but not start. We replaced the camshaft it solved the problem. It was located at the back of the engine, at the top and is held by just one screw.
