answersLogoWhite

0


Best Answer

has the same problem with a 92 Pontiac bonniville with the 3800 ended up being the cam position sensorI justot work.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause a buick 3800 to not start after it has warmed up?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What would cause a 1991 Buick Park Avenue not to start when the engine is cold?

check crank sensor


What would cause a 1988 Buick lasabre not to start after the fuel pump has been changed?

Check the fuses.


What would cause 1990 Pontiac 305 surge on start-up and run crappy until warmed up?

Bad EGR valve


Having a problem with your 1989 buick park avenue shutting down while driving then will start back up if it sits a minute?

My 92 PA had a similar problem. Either the cam or crank sensor can cause this problem. If it is the fault, the error code can be read out from the computer. Mine would fail after the engine warmed up but would start again later.


What would cause your 1989 buick park ave not to start after a snow storm?

How does it not start? is it cranking? Could be many things, battery, starter, etc.


What would cause a 2.9 ford engine to start when cold then when warmed up turned off and gone to restart will not restart many thanks?

bad starter, or solenoid


What would cause a 1994 Buick Lesabre to start hard when cold and start and run fine when warm when cold must crank a while before it will start?

check igntion coils


What would cause 1991 camaro v6 3.1 motor not start after it is warmed up?

ign spark control modual see if when it dosnt run if you have spark if no spark start there if it has spark check the redistance on injector.


Why would a 93 Buick LeSabre transmission not engage when the car is cold but work when warmed up?

Most likely, the fluid is low, or the filter is dirty.


Why would a 1992 buick park avenue keep cutting off?

I had the same problem with my PA after it warmed up. After several minutes it would start again then die. Over time, I had to replace both the cam and crank shaft sensors. Either one can cause this problem. These signals are necessary for the computer to send the fire signal to the correct spark plug. Reading the error code would tell which one is bad.


What would cause a 91 Buick centrey to idle fine for 15 or 20 min and then kill of without any check engine or temp lights not modular or comp?

where is the Kill start button on a buick century 2003?


What would cause a 1991 Buick Skylark to have rough shifting automatic transmitionand then not even start?

Try changeing the fuel filter,I had the same problem and it helped.