wheel bearings, any play in the wishbones,antiroll bar bushes,trackrod end/steering rack, tracking setup and wheel balancing or wheel conditions (out of shape) sorry for such a long list but without test driving the car its hard to say, if its a transverse engine and it was fine before the driveshaft was replaced its more than likely a tracking issue
A bad resistor or a bad switch.
Could be spark in the motor, or the distributor and rotor need to be replaced.
the transfer case motor has to be replaced
most definitely the motor mounts replacement would be the result of the accident usually motor mounts will last for years
a motor
Your blower motor is burned up. You need to get it replaced. Cost of motor, depending make and model and geographic location is approx 85.00 -100.00 figure roughly 2 hours for labor.
u need a new blower motor
Can the oil pump be replaced on 1994 Ford Ranger 4.0 without pulling motor?
you have an electric motor on the transfer case unplug it and see if you have power going to it if you do the electric motor needs replaced
I replaced the motor in my 1993 G20 with a motor from a Nissan Sentra from Japan.
There are a couple of reasons why a 1999 Oldsmobile Alero ac heater to stop working. The heater coil may need to be replaced or the HVAC blower motor may need to be replaced.
My s-10 does the same thing. I have found out that it only blows when I place the blower motor in speed 4. If I unplug the blower motor and put the switch to 4 it does not blow. I have recently replaced the blower motor and resistor and this had no effect. Hope this helps.