it sounds like a loose clutch cable. can tighten from under hood or under clutch pedal.if that year has the adjustment.
It sounds like it is the clutch cable. I have a 94 Nissan Sentra and the clutch cable just broke. I have replaced one on an older Nissan, but it is still difficult for me to do on the 94. It is really hard to get the broken cable out.
It depends on the type of clutch linkage. If it's mechanical linkage the clutch could be worn and the rod dropped out. If it's a hydraulic clutch, the clutch master or slave cylinder could be worn out.
The clutch on a 2155 can be adjusted through the linkage. By loosening and shifting it in one direction, the position of the clutch and its tension can be changed.
Check fan belt tension.
Remove the clutch cover , you might have to remove the left floorboard to remove the cover . The rear clutch can easily be removed by removing the bolt in the middle and pulling it straight outward . The front clutch requires a puller that screws into the center of the clutch .Removal without a puller will result in clutch damage .
a pressure plate works by springs. when disengaged the tension is released from the springs which hold the clutch plate against the flywheel,allowing the clutch plate to spin free,which basically stops the transfer of power from engine to gearbox when clutch is engaged the tension is reapplied to springs in pressure plate forcing the clutch plate against the flywheel
clutch pedal free play decreases
The clutch of a go kart is much the same as the clutch on a car. The clutch disengages the engine from the gearbox enabling the gear to be changed. Without a clutch gear changing would be difficult and may damage the gearbox.
You cannot physically put a clutch disk in backwards unless you force it together. If you do this you will destroy the clutch disc and possibly other clutch components.
Age, misalignment, wrong tension, prolonged lunatic clutch dropping.
A clutch replacement in your 1995 Nissan can be very difficult for a novice mechanic. An experience mechanic will take approximately 3 hours to complete the task.
Is is extremely difficult to change a clutch on a 2l hdi citroen xswara picasso car, as it is mounted directly into the main console which is generally unremovable.