answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What would cause a squealing sound when letting off gas pedal?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What causes a squealing sound when you turn the wheels completely to the right or left?

The cause of the squealing sound is because you are turning the steering wheel completely to the right or left


What is the sound a hog makes?

A hog sometimes makes a snorting sound, and sometimes makes a squealing sound.


What would cause a squealing sound from passenger side of a 2000 crown Victoria?

Have u checked the bearings?


What would cause a squealing sound when the car is idle and driving?

you need to replace your belts. Take it to AutoZone to have them look at it


What would cause a squealing sound when making hard right turns?

might be your power steering or something in that nature


What else could cause squealing sound replaced idler pulley and alternator and still makes sound?

I think we figured it out. Believe it is the throw out bearings.


Why does your car make a noise when step on the pedal?

When the turbo winds up it can make a whistling sound when a driver steps on the pedal. A loose part can also cause a rattling sound when the pedal is used.


Squealing sound on startup?

check the belts


What would cause a squealing sound after prematurely grinding a manual transmission truck into gear while accelerating?

main shaft bearing


What could be the cause of squealing noise especially when accelerating a car?

you probly have a belt slipping, a can of belt dressing should stop the sound


Squealing sound after installing a new belt?

squeeling sound after installing new belt usually means that the belt is not tight enuff. if that is not the cause, a bearing on a pully wheel may be bad


Squealing sound on a tire when the car is in reverse?

The sound is most likely the brakes squealing. Check the pads to make sure that the metal part isn't cutting into the rotor.