answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2011-02-03 06:15:41

Stopped at all faucets? Didn't pay the water bill. If in cold climate, the line from the outside to probably the water heater has probably frozen.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


The osmotic pressure. This is the pressure which would have to be applied to a solution to stop water entering if it was separated from pure water by a semipermeable membrane.



Why should it stop? For the water cycle to stop, the water would have to disappear, or it would have to stop evaporating, or stop raining.


There is no such thing as a valve cannot increase or decrease pressure IT can throttle volume or stop the flow.=One would need a pressure booster pump to increase pressure=


An angle stop is not intended to control water pressure for most applications. That being said, however, you can control the pressure with an angle stop valve (Aka angle pattern globe valve) while there is flow. As soon as the flow stops, then the pressure will equalise throughout the system. I would suggest using a PRV or pressure reducing valve. This will control water pressure under most all conditions. Source: 2nd year plumber training, Alberta


Salt is not the cause of high blood pressure - it is vital for regulating the blood pressure. You should NOT avoid salt. Drink more water instead - and stop drinking other beverages such as soft drinks, coffee, energy drinks, tea, etc. These drinks cause dehydration - the underlying cause of high blood pressure.


Check the universal joints and balance of the driveshaft. When you are accelerating pressure is applied to these parts and if they are worn or out of balance or dented they will cause a vibration that will stop when you let off the gas.


If you mean "Why does the water from the supply pipe stop flowing?" it is best to check with your local water supply utility company. Maybe they are doing some maintenance work on their water distribution network?


water pressure from the main or pump , side is greater that the lowest setting on the pressure valve, causing the diafram to viberate,


The doctor had to apply pressure so that the patient's wound would stop bleeding. The pressure to do well on the upcoming test was almost more than she could bear. The water pressure in my city was low yesterday.


A normal puddle on the road should not damage the fan. If the water is deep, then water could get inside of the fan connectors or the fans themselves, and cause failure.



When the water cycle will stop forever the rain will stop forever simple as that


A Hydrostatic valve is basically a plug that stop water coming down out of the pool, but when the water pressure under the pool gets higher then the pressure in the pool it will let water into the pool from underneath in order to stop the pool from floating in ground water.


You would have to remove all life from the planet to stop water pollution.


why would water stop soaking into the ground in the saturated zone


Someone may have shut off the water to that faucet, or a pipe may have froze, or there may be air in the pipe.


You have a problem with either the pump or the pressure regulator. Call an expert and have this repaired.


Stop the bleeding; through pressure or with a white stick you can get at pet stores. Clean out the wound; use luke warm water, soap will cause pain.


Must be that pressure is equal on both sides...


You could not extinguish the sun with water. The sun is not actually a fire; it is a natural thermonuclear reactor. The fusion of hydrogen to helium at the core is driven by the immense heat and pressure. If you were to add enough water so as to significantly increase the sun's mass it would only increase pressure at the core and make the sun burn hotter. One possible exception would be if you added enough water that the added mass would cause the sun to stop fusion and collapse into a black hole. This would probably require several hundred to several thousand solar masses.


They would either stop at a settlement with a water source, at an oasis or at a river.


we would stop getting water and die!!!!!


Replacing a bad water pump can help to stop a motor from overheating. Hopefully that was the cause of the overheating. If it does not stop the overheating, try replacing the thermostat. Make sure you have the proper mix of antifreeze and water, the radiator filled with it. Check the level of coolant FIRST. Next, the hoses, and third the thermostat. Then, disconnect a hose and see if, by starting the vehicle, if there's water pressure. If not, its water pump time!


If you stop a volcano erupting, the pressure would build up elsewhere and erupt elsewhere.



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.