Headlights Tail and Brake Lights
Car Fuses and Wiring

What would cause brake lights emergency lights etc to stop working?


Top Answer
User Avatar
Wiki User
Answered 2008-03-14 16:13:24

Check the bulbs - they are doubloe filamented with the smaller being for brake/turn signals Check the fuses


Related Questions

The BOO (Brake On/Off) Switch may need to be replaced. If it is bad, it would cause the brake lights to NOT illuminate when the brake pedal is applied.

A bad ground wire is the most common cause of turn signals and brake lights not working. The ground wire connection might be corroded.

Blown fuse, bulb, or bad brake light switch.

Check the bulbs, fuse & brake light switch on the pedal.

It is your multifunction switch that has gone out. It is located in the steering column. I used my emergency lights and it blew out brake lights, turn signals, and emergency lights. In newer models Chevy did a recall not so for our older models. Mine is a 1995.

The probable cause of the brake lights not working on your Renault is the brake light switch. The brake light switch can be found under the dashboard by the foot pedal.

Blown fuse, both lights are burnt out, There is a wiring or ground issue.

Yes it can but that is rare. The more likely problem is one of the following:emergency brake is engaged slightlyBrake switch is faultybrake fluid is lowbrakes need servicing

If the turn signal is working it's either the brake light switch or the turn signal switch.

Do you mean What does it mean when the brake and battery lights come on in when it is already started? Check your alternator may be its not working well it cause the battery sign comes out.

It is possible that a wheel speed sensor is bad. This will cause the anti lock braking to not read the wheel correctly which would be a brake problem that would cause a light.

A malfunctioning brake light and flasher relay switch will cause the brake lights and flashers to stop working. The relay switch can be found below the dashboard on the drivers side of the passenger compartment.

Bad switch, bad relay, short to ground in the circuit.

Have you first checked the fuse, that's the first place to look. The second place if the fuse is OK is the brake light switch and that;s on the brake pedal bracket, check the wires and just press the brake pedal and listen to see if you can hear it working, someone to look at the lights is helpful.

Front emergency brake? Do you mean a frozen cable? If front brake is locked may be a frozen caliper Emergency brake tied to rear brakes only

The emergency brake cable is probably seized and the emergency brake is not releasing.

Yes the emergency brake cables can freeze up but will not cause a problem until it is applied.

The most probable cause is that the brake light switch is out of adjustment.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.