TRY REPLACING THE FULE FILTER.YOU ALSO COULD HAVE CLOGED FLUE INJECTORS TRY SOME INJECTOR CLEANER .OR YOUR LOCAL SHOP CAN HAVE THEM BLOWN CLEAN Check the wire that goes to the O2 sensor, it easily comes disconencted in the little plug that clips onto the radiator next to the PS pump. If the above answers don't work, try cleaning or replacing the idle regulator (it can get a lot of carbon buildup). It's on the throttle body where the air intake links up and just behind the throttle cable. Held on by two star bolts. -Jegoyet
Bank 1 oxygen sensor is the closest to the engine exhaust manifold. It is usually can seen and replaced if necessary with open hood.
Oxygen sensor is located at the exhuast Manifold.
exhaust manifold
Bank 1 sensor 1 is the first oxygen sensor usually in the exhaust manifold. Usually it needs to be replaced. Sometimes it can just be a bad connection in the plug for the oxygen sensor.
the oxygen sensor is on the exhaust manifold directly in front of the fan. there is one above and below the manifold.
the oxygen sensor in located in the exhaust manifold under the intake manifold at the back of the engine
oxygen sensor is found either in exhaust manifold or in actual exhaust pipe between manifold and muffler
If the Nissan truck is either a V6 or a V8, the oxygen sensor will be located in the manifold. Sometimes it will be placed just below the manifold.
The Exhaust Manifold Oxygen Sensor needs to be replaced.
its the 1 on the exhaust manifold pointing out towards the front of the car. i just replaced it on mine
By "exhaust manifold sensor" do you mean the O2 or oxygen sensor? The only sensor I know of on a exaust manifold is the O2 sensor and if you follow the manifold you will see 2 sensors sticking out they will have (usually) green wires coming from them
The oxygen sensor is located in the exhaust manifold before the catalytic convertor. If you look down between the radiator and the exhaust manifold a few inches before the exhaust pipe connects to the exhaust manifold you will see the Oxygen sensor. The sensor will have 2 wires coming from it and it kinda looks like a sparkplug stuck into the exhaust manifold. There is 2 nuts that hold the oxygen sensor into the exhaust manifold.