answersLogoWhite

0


Best Answer

Throttle Control Sensor.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause the RPM needle of a 1997 Honda Civic to go down to the point where the car stalls and wants to turn off when one puts it in drive or reverse?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why my Honda civic 2000 starts then idle drops and stalls?

Idle Air Control Valve.


Is crankshaft bolt 95 Honda civic reverse thread?

NO


Is the crank pulley bolt on a 1993 Honda Civic reverse threaded?

No it is not.


Honda civic 98 ex stalls when you put it into drive or reverse after 20 feet.?

This is most likely the sign of a faulty timing belt. There could also be an obstruction in the drive line. This could also be a symptom of overheating.


Why is a Honda Civic called a Honda Civic?

cause its a civic that Honda makes


Why does the RPM needle go down when you put the 1997 Honda Civic in drive or reverse?

because in park or neutral the engine is free revving and when put in gear the engine is now turning internal transmission componets which puts a load on the engine


I have a 89 Honda Civic DX Hatch I swapped out with a 95 Civic EX D16Z6 motor and did a DPFI to MPFI swap but when I rev the car it goes but after 2000 RPMs it stalls can anyone tell me why?

Check you TPS.


What are the symptoms of a faulty oxygen sensor 1996 Honda civic?

Check Engine light is on. Engine OK when cold, but when reaches operating temperature it stalls at idle.


What is the reason for my speedometer needle on my 1996 Honda civic goes on and off stops then works?

re-wire your speedo clip. it worked for me.


What would make the rpm needle rev up and down in 1990 Honda civic while the car is in PARK and running?

senor


Will 98 Honda Civic seats fit a 93 Honda Civic?

Will a Honda civic seat fit a 93 Honda accord.


How do you fix a Honda Civic that stalls after driving and restarts and stalls again?

You should try to to replace you distributor cap and rotor, because over time it tends to wear off. Plus you should check the ignition coil. this should do the trick.