might be a fuse
The lights on the odometer on a 1999 Chevy Blazer might not work because of a burned out fuse. They might also not work if the lights are burned out.
A blown fuse can make your dashboard lights to not work in your 1993 Chevy Blazer Tahoe. A burned out bulb can also cause this.
Probably a blown fuse. What you need to find out is why the fuse blew.
engine misfire. i have a '96 Chevy blazer but i don't have that problem, i was reading reviews on the car and found out that some of them do that.
There are several things that can cause everything to go dead when you bump the starter. The most common cause will be a loose or corroded ground wire.
It is your multifunction switch that has gone out. It is located in the steering column. I used my emergency lights and it blew out brake lights, turn signals, and emergency lights. In newer models Chevy did a recall not so for our older models. Mine is a 1995.
Probable cause Flasher Fuse control lever
Head gasket or cracked head. Mo
A bad engine temp sensor can do that.
A faulty alternator, a faulty belt tensioner.
i had this same problem, it was the headlight switch, cost about 30 bucks in a 2002. it also messed with the navigation system
A front popping on the left of a 98 Blazer could be the brakes, steering, or wheel bearing. Check all three to find the cause.
check for vacuum leaks that wull usually cause this problem
low on oil, crankshaft and bearings bad
Could be several reasons, need to know aprox where it is leaking from.
The seat belt might not fasten in a 2000 Chevy Blazer because there is a foreign object in the slot where the seat belt fits. Even the tiniest of objects can cause the seat belt to not latch properly.
There are several things that can cause shifting problems in your 1989 Chevrolet Blazer transmission. The most common cause of shifting problems is a lack of transmission fluid. Broken shifting forks can also cause transmission shifting problems.
Blazer does not take off like it should. sluggih slow take off then after it gets going it does wee.
Several problems can cause a 1999 Blazer not to start. There could be a fuel problem or a firing problem. Check for fuel pressure and ignition spark first.
over charging or bad bearings its about to let you stranded change it
Cheak fuel pression in the morning.
replace the catalytic converter
more than likely some of the wires are loose
I have a 2000 Chevy Blazer LT and it ran great until I took it to a Valvoline for an oil change. I had over 160,000 miles on it and they put the wrong oil filter on it to cause my engine to seize. Jeff- Sioux Falls, SD
Blown fuse, both lights are burnt out, There is a wiring or ground issue.
It's toast, replace it. Or have flying chunks of metal stuck in your ass.
That is True.. A faulty speed sensor will cause no shift or late shift..
Bad ideal. Why would you want to ? It would just cause bad problems later.
have you checked your fuses?
Your 1983 Chevy S10 Blazer might stall when the accelerator pedal is depressed because of a clogged or dirty fuel filter. Gas that is mixed with water or condensation from the tank can also cause this issue.
There are several things that can cause your 1998 Chevy to randomly die out. The most common cause is a malfunctioning fuel pump.
Check the 96 Blazer for any vacuum leaks in the system. A vacuum leak can cause the air flow to only come out of the heat vent.
In those tail lights there is a circuit board. If it goes bad it will cause all kinds of problems.
Loose Lug nuts bad control arm...
Check Antifreeze level..make sure there are no leaks under the vehicle.
Check the light for condensation. There could be a short that has cause the light to malfunction. If so, the entire light unit will have to be replaced.
The most common causes are the bulbs themselves, but another problem could be your hazard realy itself, its kinda like a fuse, idk where its located but if it went bad, the flashers stop operating, its a cheap fix, just have to find the relay.
If you are here looking for the answer then you to invest in a chiltons repair manual for the vehicle cause it is a job that is or could be very complicated.
These lights have 2 different "lights" in each of them. This occurs frequently. Change out the bulb and everything will be working fine once again.
burned out bulb, blown fuse, wiring
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
Either a faulty thermostat or you have a low coolant level.
Yes, along with hundreds of other things. See related questions below.
That is anti freze they changed the green that year to orange.For some reason Chevy wanted to be different.
Faulty ground to the dash.
There are a variety of issues that can cause the tail lights to stop working in a 1993 Chevy S-10 pickup. There may be a blown fuse, a damaged wire, or the bulbs may be burned out.
The fuse box is on the right side of dashboard when door is open, tail light fuse will cause tail and dash lights to go out.
Did you check for a blown fuse? Look for one marked TAIL LIGHTS. This is the one that would affect that would affect the tail lights and license plate light.
it is most likely a fuse or at worst the turn signals and stop lights work through the turnsignal switch
If it is just that rim,your brakes could be dragging.Inspect,or have them inspected by a Chevrolet dealer or an ASE certified mechanic.