It may just be a screw came loose underneath your gear shifter. That is what happened to me. Just slide the stuff up to the top of your gear shifter and look underneath. If one of the bolts is udone, just simple put it back on.
A loose wire can cause a radio to stop working in a 2008 Jeep Wrangler. A blown fuse is another cause and can be fixed by replacing it.
blown fuse under hood check all brake fuses....also could be bad relay at shifter u have to take shifter loose to replace at bottom of shifter
Check the starter relay on the right side above the fender the little red wire going to the top sometimes comes loose
The first cause of the jump out from one to other gear is the loose shifter fork, which connects the shifting linkage and gears of the transmission. The second cause is loose shifting linkage itself, which connects the gear shifting knob and shifting fork. The shifting linkage and shifting fork become loose due to the rapid changing of gears from one gear to other at high speed of vehicle. The third cause is the misalignment of shifting linkage to the shifting fork.
shifter bushing has been worn out. should be able to repair under the car.maybe Civic Shifter Bushing Kit-Energy Susp #16-1101r
the plate that holds the shifter to the trans is loose, you should be having more shifting issues as well. Remove the plate that goes around the shifters on the floor to access the mounting bolts and tighten them.
Not really describing answer , but i would assume you shifter cables have broken
serpentine belt loose
Most common cause is that it is too loose, but make sure none of the pulleys or driven accessories are bent or out of alignment.
first most obvious, make sure the transfer case is not in neutral. If the shifter is stuck in one position you can access the floor panel over the shifter, then remove the shifter, sometimes when worn or loose they can become stuck and you can fix it by lifting the shifter out of the trans. Lastly, and you would probably already suspect this, the clutch is gone, but you would have had a lot of issues and slippage leading up to a complete failure.
I have this same problem. A broken shifter box. I will repost a fix as soon asap.
Look for a loose plug, or plug wire.