You would short out the battery. If it was a car battery capable of 300 amps and the wire was big enough, the battery could explode.
series resonant circuit
A simple series circuit is typically used in a battery-operated torch. This circuit allows for the flow of current from the battery through the light bulb, providing illumination. The components are connected in a loop, where the positive terminal of the battery is connected to the light bulb and then back to the negative terminal of the battery.
The equipment is all connected in series with each other to make a complete electrical circuit.
If a 9.0 volt battery is connected to a 4.0-ohm and 5.0-ohm resistor connected in series, the current in the circuit is 1.0 amperes. If a 9.0 volt battery is connected to a 4.0-ohm and 5.0-ohm resistor connected in parallel, the current in the circuit is 0.5 amperes.
In resistive circuits,when you need the same current in the whole circuit,you use series circuit because in series circuit current remains the same.If you have two batteries of 12 volts each,and you need 24 volts you can arrange them in series to get 24 volts you have to connect them combine with opposite terminals.positive of one battery will connected with negative of other battery,and negative of second will connected with the first's battery positive terminal,they are in series now.
If it is connected in series with a circuit then it might raise the resistance too high and fail the system. Parallel connection is a circuit is probably the best bet you have.
1 volt
The voltage depends on how the two batteries are connected to one another. If they are connected in a series circuit (positive end to negative end) the voltage will double. If they are wired in a parallel circuit, (It
A circuit in which elements are connected in series.For example in RLC series circuit resistor,inductor and capacitor are connected in series.
In a series circuit, the voltage is the same across all components connected in a series. This is known as the series circuit voltage.
It is a series circuit with all the components connected in series.
To connect two batteries in series, you would connect the positive terminal of one battery to the negative terminal of the other battery. This creates a circuit where the voltage of the batteries adds up, providing a higher total voltage for the circuit.