answersLogoWhite

0


Best Answer

poopin

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would make the stop lights quit working on a Lexus LS400?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would the Radio stopped working in a 1998 Lexus es300 fuses not blown?

Radio in 1990 Lexus LS400 stopped working, possible answer?


How much would it cost to rebuild air conditioner for Lexus 1990 ls400?

Look forward to a bill of over $2000! I had my 92 Lexus LS400 converted for $2,456! :(


Would a 1993 Lexus ls400 rear air shocks fit a 1991 ls400 rear?

Yes these are the same from 90 to 94 models www.lextechautomotivellc.com


What size belt is needed to bypass the ac compressor on 1993 Lexus ls400?

it would be a 5 by 6 belt for a magnum for a Lexus you would need a 3 by 7


Why would a 90 Lexus LS400 overheat rapidly when a new thermostat was installed and the engine coolant is full what could be the cause of this problem?

check the water pump


What does it mean when the dash lights flicker in my Lexus?

On my Lexus I had an issue with the lights staying off when it was cold. This was the case for all of my dashboard lights. Then they would flicker back on. There are Caps on the board for the instrument panel that were blown. This was the case for my fuel cage that didn't work consistently work as well


Where is the starter located on a Lexus ls400?

The starter is located on the top of the engine, at the rear of the engine. In order to get to it you will need to remove the entire intake system from the engine. I would recomend you take it to a mechanic that is familiar with the Lexus. I have had to replace 2 on my LS 400 and I had it done at a local Toyota dealer. This is about a $800.00 job.


What would be the causes of brake lights not working on a mustang?

That the lights need fixing maybe?? That the lights need fixing maybe??


What would be the cause of no tail lights and no cluster lights when the fuses and bulbs are working?

If the parking/tailight fuse is good - then it may be a bad headlight switch No tail lights but the bulbs are working? Please explain.


Why would a 1990 300e Mercedes Benz brake lights and reverse lights stop working?

burnt out lightbulb!


What would cause the 'rear light failure warning' light to stay on in a 1996 Lexus ES300 even though no bulbs are burned out?

It may caused by a light installed that don't match the factory specifications, could be the wattage is a bit off or something of that nature. It could also be the lamp failure sensor. On the LS400 it is located in the trunk on the drivers-side just behind the backseat. The sensor activates the warning light when there is a break in the circuit for the brake lights or the tail-lights.


Why do the tail lights not come on 1998 ford ranger which fuse is it?

if turn signals are working , and brake lights not working, i would replace the stop light switch on the brake pedal