from memory the correct size wrench is 9/16 inch box
The wrench warming light on the dash of the Ford F250 means that there is a mechanical failure on your vehicle.
to loosen belt tensiomer, u can use a 1/2 inch drive socket weench or buy proper tool for it the part of socket wrench that socket goes on, will fit in the square hole in front of tensioner once this is in place push wrench towards centre of vehicle enuff to remove belt then slowly release pressure on wrench
a T-50 star bit is needed to remove the bolt
have you tried the proportioning valve. sometimes dirt will get in there and clog the returns.
how to remove rear axle from 1988 f250 ford
Yes you can
Lift the car, remove the tire, remove the brake shoes/calipers, remove and dispose of the old pads. Put in the new pads, replace the brake shoe/caliper, replace the tire and lower the car.
Jack up the F250's front end. Remove the wheel. Remove the locking assembly, this will be different depending on which assembly is used (skip this step it the F250 has the slide on type rotor.) Unbolt the brake caliper and swivel it out of the way. The rotor was either unbolted during the locking hub removal, or it is the slide on type that will now just pull off.
wrench for lug nuts on f250 is 7/8s of an inch there is a metric wrench that fits but i cant remember what size it is
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing retaining nut. Remove the axle seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
yes, u can make anything fit if you know what you are doing
how do you remove the radio from an 06 f250