0
What wrong when a 4 wheeler will run when pour gas in the carburetor but will not run on its own Honda4 wheeler?
Wiki User
∙ 14y ago
your main jet is plugged
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why does petrol pour out the plug hole on my lawn mower?
Carburetor float is stuck open.
Where do you pour oil in a 250 Arctic Cat 4 wheeler?
You probably have to mix it in with the gas.
Why would gas pour from the overflow on the carburetor on Yamaha riva razz sh50?
Bad needle/seat valve on carb.?
When you pour gas in your carburetor 1995 Jeep Cherokee starts and runs but just turns over if you don't what is the problem?
fuel pump
How do you clean the carburetor of a 1998 Toyota Tercel?
There is no carburetor on a 1998 tercel, it's fuel injection. Just go get a can of sea foam mootor tune up in a can and pour into your fuel tank. and that should clean your fuel injector nozels.
Your 1988 Mazda rx7 will not stay running unless you pour gas directly into the carburetor?
Sounds like a dud fuel pump to me. Check all the wires first . Funny though , 87 rx7 had no carburetor...it has electronic fuel injection.
Why will engine only start when you manually pour gas down into the carburetor?
Almost always the fuel pump. Slight chance of the injector, but normally the fuel pump.
How do you fix valves in Jeep Cherokee?
What's wrong with them? Are they stuck? (You can try the old trick where you slowly pour transmission fluid into the carburetor while the engine is running, taking care not to stall it. Don't do it near your neighbors, because it creates a hell of a lot of smoke). Are the valves burned? If so, then you'll have to pull the head.
What if the equivalent of a tablespoon of transmission oil got poured into the engine accidentally?
It won't hurt it at all .old mechanic's use to pour it through the carburetor to build the litters up
What else would you replace on a 1988 Chevy Corsica if the car wont start unless you pour gas directly into the carburetor?
fuel pump is the first place i would look
Why would gas pour out of a carburetor on a 1969 Chevy pickup that a new kit has been installed?
Float level to HIGH, Needle and seat not installed correct are damaged. Carburetor not CLEANED correct. Fuel pressure to high. That engine should only have 6 to 9 lbs. of fuel pressure.
What if you pour coolant into the overflow and the coolant instantly pours on to the ground what could be wrong?
A leak. You need to see where it is coming from.
