1968
is this rear wheel drive? RWD's don't have AXLE "joints"
What car? Be specific, it's not like we can pop out of your computer and look for ourselves yanno. ;)
You did not say what year it was, and that makes a difference. But you can check these things--- U-joints in front drive shaft, Front CV joints and axel shafts.
take off the wheel. unbolt the 2 lower strunt bolts, to swing the brake assembly out, pull that end of the axel out, then give the axel a good pull out and it should pop out of the transmission.
Bad axel shaft u-joints. U-joints bad in the front driveshaft. It would really help to know the year.
Yes you can.
how do you change rear brakes on a 1990 Honda trx 300fwl
howdo you change the front axel of a dodge Dakota 2000 4x4
An Axel is when you jump forward into mid-air and turn one and a half rotations in the air.You land backwards on the opposite foot you took off on.
MOST COMMON CAUSE OF NOISE FROM FRONT AXEL ESPECIALLY IN OLDER CARS IS THE CV JOINTS IF IT GETS WORSE WHEN YOU MAKE TURNS ITS THE CV JOINT............
you need to check the front axel u-joints NEUTZ
beleave it or not its cheaper to buy the axel than jusy the cvjoint, its not that hards to replace an axel, you need to remove the tire on that side, you will see a big nut in the center of the wheel that is your axel nut take the nut loose then you will need a hammer drive the axel thru until it is free, then you will see your strut theres 2bolts running thru the strut remove the 2 bolts after removeing the bolts from the stut pull down on the spendel and release the axel after the axel is free from the spendel grab the axel and pull it out of the trasmision not sometimes it can be hard but it will come so don't be worred and to replace the axel do everthing in revers.note after replaceing the axel the car has to be lined up you can call the parts store and they can tell you how tight the axel nut has to be. i hope this will help you