Answerif its a lsi it is four cylinder if not it is the three cylinder There is a sticker under side of hood that specific engine for your car
what year was geo prisms made
I believe Chevrolet
Answered by this question:Using the vin numbers to tell which model Geo Prizm you have?
yes, if it's a 3 cylinder Mr Geo Metro yes, if it's a 3 cylinder Mr Geo Metro
Yes the Geo Prism has ait bags.
You gotta get under the car and do it from the back of the engine.
Yes , according to the Gates website ( they make timing belts etcetera ) the 1.6 liter and the 1.8 liter four cylinder engines used in a 1997 Geo Prizm ( ARE NOT INTERFERENCE ENGINES )
where can you find an engine diagram of a geo metro 3 cylinder 1.0L engine
The average cost to replace a transmission for a Geo Prism will vary depending on the cost of labor and the year of the Prism. On average, it will cost between $3,500 to $4,000 dollars.
in the fill resivor attached to the master cylinder assembaly
The Torque Specs for a 1992 Geo Prizm are 101 ft-lbs @ 4800rpm. In addition it has a capabilty of 102hp at 5800rpms.
From under the car. It's on the backside of the engine between the engine and firewall. Just about smack in the middle.
where is the fuel filter located on a 91 geo prism?
GM made a small car called the geo prism. GM Chevrolet or GEO
No. The Prism motor is a Toyota motor and side mounted. The Tracker motor(suzuki) is mounted with the engine from front to back, so it will not work without a lot(I mean a lot) of work to do it.
it can be done but you will have to change all of ur wirring harness from the prism because the prism is basically a Toyota and a storm is a izuzu impulse knockoff
16 valve 1.6 liter 4 cylinder.
It all depends on the size of the engine, but there should only be one.
There are now not many cars in the United States that are made with a 3 cylinder engine. A couple of the vehicles that were once made with a 3 cylinder engine is a Geo Metro and Dihatsu Charade.
Timing belt ( for both the 1.6 liter and 1.8 liter - 4 cylinder engines )
The engine and transmission of a manual 3 cylinder weighs 135lbs.
Same answer as: "How do you replace a starter on a 92 Geo Prism LSI or GSI?" at this same site.
Look under your exhaust manifold on the front of the engine. Towards the passenger side.