Get fast answers to your Toyota Cressida questions from experts in the CarGurus automotive community. ... and piston rings on my automatic Cressida but the crank won't turn please help ... have done all thing related to mthis problem but it is not solved what shoould i do? ... Starts right up, runs for 10-15 min then cuts off.
Look for spark and fuel 1st then comeback
The cold start injecter is located in the middle of the intake manifold with the brake master cly. right in the way
CHECK THE FUSE THATS UNDER THE HOOD
There could be several reasons why a Toyota Sienna will not start. the most common problem would be a dead battery.
The knock Sensor in a 1989-1992 Toyota cressida is located under the intake manifold, closer and under the cold start injecter. Behind the alternater. i had to use a small mirror to see it, or you can put your hand under and search for it. Also look at this tread forum: http://www.toyotanation.com/forum/showthread.php?t=213375 Thanks
Try asking a question.
fuel stop solinoid problem,or air in the lines
use the ignition key to turn to on or to start and the system should reset. I stopped using mine because it would trigger at any time wothout an intrusion
start by checking choke operation but it sounds like MAP( Manifold Absolute Pressure ) sensor is going bad be sure to disconnect battery before starting project the reconnecting after everything is mounted and hooked back up to prevent shorting out electrical sensor
chances are to start with the fuel filter if that's not it try the fuel pump
i don t know really anything about cars but my 4-wheller used to do the same thing and it was the carborator,could be the same on a car?call Toyota and ask them:)best solution
Havingg a problem with the remote saying can't read