Havingg a problem with the remote saying can't read
This is how to reset "Maintenance Required" light on Toyota Camry with "Smart Key" feature.This works on 2007 and newer Camry models, including the Camry Hybrid. Put the odometer on "Trip A." Turn off the car, hold down the odometer button and, without putting foot on the brake, push "Start" button twice (while continuing to hold down the odometer button). Watch the display . . . it will speak for itself.
on 1998 Camry turn key on push and release alarm button turn key off then start
Opened the 1998 Toyota Camry hood compartment. Take hold of the light bulb connector. Push the connector in and turn at the same time. The light bulb will come out. Reverse the process to install the new light bulb.
put a jack under the engine to hold it up push the pin out should come off
I'd push the washer button until it was empty and then refill it.
on my 2010 - push and hold the button
try putting gas down the carb just a little or if standard try push starting
This is how to reset "Maintenance Required" light on Toyota Camry with "Smart Key" feature.This works on 2007 and newer Camry models, including the Camry Hybrid. Put the odometer on "Trip A." Turn off the car, hold down the odometer button and, without putting foot on the brake, push "Start" button twice (while continuing to hold down the odometer button). Watch the display . . . it will speak for itself.
Park your car on car ramps or on hill with sharp incline, then start the engine and run it for 10-15 minutes at least. It should push out air trapped in the engine.
yes but you have to push in your clutch start cancel button
My 92 has a safety feature where you have to turn the key to the off position, and then you must push the key in and turn one more time in order to release the key.
I have a 2010 mitsubishi galant i have to push the gas to start the car what's wrong