For the Contour/Mystique/Mondeo front wheel bearing, tighten the axle nut to 290 newton meters, or 213.89 foot pounds.
175 ft lbs
103 ft lbs
185 to 260 ft lbs this is the front center nut that holds axle and front wheel bearing together not wheel lug nuts
Answering "What is the wheel bearing torque specs in ftlbs on a Ford 10.5 rear axle on a 2002 F350 Super Duty 4x4 non dually diesel?"
remove front wheel, remove complete brake assembly (2 15 mm bolts) remove brake disk, remove old wheel bearing bolts, 3 13mm bolts from rear side, disconnect antilock brake wire, remove center axle nut, 33mm, tap end of axle to loosen axle from bearing, remove bearing. install new bearing with center axle nut torque 120 lb, 13 mm bolts with 85 lb torque, install brake disk and wheel.
A semi-floater axle is one that all the vehicals weight and rotational torque are placed on the outside bearing and axle. A full-floater axle has a separate bearing assembly on the end of the axle housing to support the weight of the vehical and rotational torque is the only load on the axle shaft. A full floating axle is easy to spot because the bearings protrude through the center of the wheel.
A semi-floater axle is one that all the vehicals weight and rotational torque are placed on the outside bearing and axle. A full-floater axle has a separate bearing assembly on the end of the axle housing to support the weight of the vehical and rotational torque is the only load on the axle shaft. A full floating axle is easy to spot because the bearings protrude through the center of the wheel.
You can replace the front wheel bearing, on your Kawasaki Mule 3010, by removing the axle. With the axle Remove the wheel bearing will slide off.
Front wheel bearings are pressed in using a hydraulic press, no torque setting. However, the wheel hub retaining/axle nut that you need to remove and replace in order to change out the bearing needs to be torqued down to 233 ft-lb.
Remove the tire and wheel. Remove the axle end. Remove the axle seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
270 Nm
Remove the tire and wheel. Remove the axle end cap. Remove the bearing seal. Remove the bearing. Reverse the process to install the new bearings.