This question makes no sense.
If more information had been given - concerning at least some details about "the manner shown in Figure 52" - then someone might have been able to give a better answer than this one...
There is no circuit shown in your question. It is not possible for us to see your homework paper and answer this question.
Yeah...its possible to test the transistor using Cathode Ray Oscilloscope (CRO). CRO provides a function called "Component Testing". Just connect the transistor terminals between two pins provided by this function and you can observe the patterns on the CRO screen. Normally, in case of transistor, The operation is divided in few parts. 01. Observe the pattern for CB configuration. ---- For this, connect the terminalsfrom CRO between this Collector and Base terminals and you can observe the pattern shown by CRO. Same procedure should continue for CE & BE configuration so as to test the transistor.
It shouldn't. The open end of a non connected neutral should have the same potential as the voltage feeding the circuit. The only time a voltage will show is when the return neutral is tested with a meter to the neutral bar or the ground return bar. It will then show what the supply voltage to the connected load is. Once this neutral is connected to the neutral bar there will be no voltage shown across the test meter between the neutral and the neutral bar or the ground bar.
it is a mode of amplifier connection where the base part of the transistor is made common to both input and output.the circuit diagram is as shown below. the transiator gain(represented by the greek letter beta-B) is usually evaluated by the formula B=output current divided by input current. as we know that when the transistor is connected in common base mode the input pert will be emitter and the output part will be collector and we know that the collector current is quiet less than emitter current. as per the formula gain will be less than one. practically we consider emitter current as equal to collector current and hence B approaches 1 in case of common base mode amplifiers.as the gain is very less it is very less used as amplifiers. generally they use common emitter mode for amplification as this mode optimum amount of amplification.
The transistor has three regions, emitter,base and collector. The base is much thinner than the emitter while the collector is wider than both. However for the sake of convenience the emitter and collector are usually shown to be of equal size. The transistor has two pn junctions that means it is like two diodes. The junction between emitter and base may be called emitter-base diode or simply the emitter diode.The junction between base and collector may be called collector-base diode or simply collector diode. The emitter diode is always forward biased and the collector diode is always reverse biased.
A PNP transistor can be used as a power amplifier in a circuit because it can handle high power levels and provide amplification by controlling a large current with a small input signal. In Figure 52, the PNP transistor is configured in a common emitter configuration, allowing it to amplify the input signal by controlling the current flowing through the load connected to its collector terminal. The transistor acts as a switch that modulates the output current based on the input signal, providing amplification of power.
Most transistors have three leads. This is true even in power transistors which use the external case or housing to connect to the collector, because the circuit which uses the power transistor must still use three wires to connect to it.
arrows are shown for conventional current, not electron current.
one
In a series circuit, there is only one path for the charge to flow from the power source through various components back to the power source. This is because the components are connected one after the other in a single loop.
Only one path
No... not in the manner shown on The Sound of Music.
when a light is shown on a material.Electrons emitted in this manner can be called photo-electrons
Capillaries are not shown on the diagram because the are too tiny. They are the smallest blood vessel and are connected to the veins.
A closed circuit is a kind of electric circuit in which the path that the electrons follow forms a complete circuit.
There is no circuit shown in your question. It is not possible for us to see your homework paper and answer this question.
No because a circuit without power applied can only be shown to be a short circuit after the power is applied between the 'right' two points.