If you increase the voltage applied to a conductor, the current increases.
That is, unless you are talking about stepping up the voltage with a transformer with the intent of distributing it over a long distance to a remote transformer, at which point you would step it back down. In this case, the current would decrease. The above answer to the original question remains valid, however, due to lack of information.
If all environmental conditions remain constant then the resistance will not change appreciably with applied voltage, but the current will increase. An increase in current will raise the temperature of the conductor which will increase the resistance somewhat.
Increase, decrease, or remove the load <<>> Change the voltage and the current will also change in direct proportion, Ohms law.
Decrease, because W = I (current) x V (voltage), if one increases, the other decreases in proportion to the increase of the other. Ohm's Law states current is directly proportional to the applied voltage and inversely proportional to the resistance of the circuit.
It depends on whether the material is ohmic or non-ohmic.If it is ohmic, then it will obey Ohm's Law, and its resistance will remain constant if the current decreases.If, on the other hand, it is non-ohmic, it will not obey Ohm's Law and, if the temperature of the conductor falls (assuming it is a metallic conductor) due to the fall in current, then its resistance will fall too.
No. Power is constant. Transformers neither increase nor decrease power, except for minor losses. They increase or decrease voltage, and they decrease or increase current, but the product of voltage and current, i.e. power, remains the same.
If all environmental conditions remain constant then the resistance will not change appreciably with applied voltage, but the current will increase. An increase in current will raise the temperature of the conductor which will increase the resistance somewhat.
No, the resistance of a copper conductor does not vary according to applied voltage. It is constant for a given wire size, and only varies with temperature. Of course, current through a conductor causes it to heat, so current, not voltage, indirectlycauses a change in resistance.
voltage is applied to a conductor to cause a current flow
As we know , resistance(R) is directly proportional to length(L) of conductor and resistence(R) is inversely proportional to current (I) and I=nAqv (v is drift velocity) So , if we decrease the length of the conductor , resistance of the conductor will decrease and current(I) will increase and drift velocity of free electrons will increase . And as we know resistance and temperature have direct relation so , by decreasing the temperature resistence will decrease and current will increase . So drift velocity will increase .
An increase in an electrical current will cause magnetism to increase but a decrease in an electrical current will cause magnetism to decrease.
Increase, decrease, or remove the load <<>> Change the voltage and the current will also change in direct proportion, Ohms law.
Decrease, because W = I (current) x V (voltage), if one increases, the other decreases in proportion to the increase of the other. Ohm's Law states current is directly proportional to the applied voltage and inversely proportional to the resistance of the circuit.
When a voltage is applied across it.
current decrease
It depends on the current asset, so the change of current asset might be increase or decrease cash flows.
Area of cross section: Resistance R is inversely proportional to the area of cross section ( A) of the conductor. This means R will decrease with increase in the area of conductor and vice versa. More area of conductor facilitates the flow of electric current through more area and thus decreases the resistance. This is the cause that thick copper wire creates less resistance to the electric current.
Increase or decrease in potential results in the change in direction of the flow of electric current.