LCD monitors use a back light to generate the light needed for the LCD panel to operate. In most monitors, the light source is a cold cathode tube or several of them. As the tubes age, they tend to get dimmer. That is probably the most likely cause of the problem but it may also be the power supply that drives the tubes, known as an inverter.
There are other possible causes but the back lighting is certainly the first place to start looking.
-----------------------------------------------------------------------------------------------------
Video Inverter
video inverter page 1153 second paragraph
A precision made Swiss watch perhaps.
If you are getting a code about cam/crank misalignment, you most likely have a problem with the timing belt. There is either a part failure or it is miss installed.Niether the cam or crank sensors have any adjustments.If you are getting a code about cam/crank misalignment, you most likely have a problem with the timing belt. There is either a part failure or it is miss installed.Niether the cam or crank sensors have any adjustments.
The inverter. The inverter converts DC to AC used to power the back- lighting of the LCD panel. Check with the notebook manufacturer to confirm that it makes sense to first try replacing just the relatively inexpensive inverter board before you replace the more expensive entire LCD panel assembly.
The likely word is the transposition contrast (comparing differences, or brightness range).
It can be burned
Probably not. The brightness of your shorts/jeans would most likely cover it up.
the car will most likely not start
what;s the likely problem expected on a 4runner engine of 310000 km milleage?
If your valves are way out of range you could contact the cylinder head or the piston and possibly bend the valve but it isn't likely they would be that far out of range. If you have hydraulic lifters you shouldn't have that problem. With solid lifters, be sure to slacken all of the adjustments.
It can, but it should not. If it does, then the reed-switch is defective ... its contacts have most likely deteriorated on account of excessive current at some time.
That person would have a problem with his metabolism.
The printer does not have enough memory to hold the entire page