0
When did they start putting the 327 cubic inch engine back in the pick up?
Wiki User
∙ 12y ago
Chevy still has NOT reproduced the 327 CID engine. It is NOT used anymore. Alot of people call the 5.3L smallblock chevy a 327 and it is NOT a 327. It is a 325 CID / Cubic inch desplacement engine and that is 2 cubic inches smaller then a 327 engine. That is NOT much but it still is not a 327
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How many cubic inches is a 5.8 liter engine?
Ford's 351 cubic inch V8 engine is a 5.8L ( but back in the 1960's Ford also calls the 352 a 5.8L )
After putting the ds back to factory settings how do you start a game from scratch?
L R start Select
Why does engine rev up on your focus after starting could it be throttle body problems?
It's supposed to do that. It is the "dash pot" emulating putting your foot on the accelerator to start the car. The computer does all that for you. Keeps stupid people from flooding the engine out. That is your "dashpot" at work. It's supposed to "rev up" and then calm back down. It imitates putting your foot on the accelerator
Where is reservoir for putting power steering fluid in a Nissan Ultimo?
drivers side back of the engine compartment
Mazda 5 speed you drove it today and parked it when you got back in it will shift to 1st and 2nd gear wont go to the other ones and wont move when its in 1st and 2nd?
clutch gone try putting into gear then start engine be ready to shut engine off
Where is the starter located on a 1995 Chevy silverado 350 cubic in engine?
Standing in front of engine, it is on the left back bottom side of engine. You will have to lay down under passanger side of engine and look up.
What year did Chevrolet install the 350cu engine in a camaro?
They had them as a stock engine from 67-81. Then they started putting other engines in it like the 4 cylinder and 6 cylinders. But they started putting them back in at 87. It has been optional since.
Where is the flywheel located on a camaro z28?
On the back of the engine, mounted between the engine and transmission, inside the bell housing. You cannot see the flywheel. The starter is connected to the flywheel when you start the engine.On the back of the engine, mounted between the engine and transmission, inside the bell housing. You cannot see the flywheel. The starter is connected to the flywheel when you start the engine.
How to remove a 1996 ford aerostar 30 liter engine?
Pretty major undertaking. Taking it out is a lot easier than putting it back IN however. You should start by picking up a comprehensive mechanic's manual for that make/model.
What to do when the engine stop at a lght but start back up?
when driving a mazda360z
How you get pressure back after changing fuel filter?
Just start the engine.
Can you put 1991 eagle talon enigne into 1992?
Yes you Can... it is extremely easy! You would do it like you were putting the 92 engine back in it!!
